Cisco光纤交换机配置说明V1.0.docVIP

CISCO交换机配置 撰写：李克 2007-1-26  1. 初始化信息 3 2. 交换机配置 4 2.1. 配置交换机管理地址 4 2.2. 配置VSAN 4 2.3. 配置ZONESET 4 2.4. 配置ZONE 5 2.5. TRUNKING的配置 5 3. 图形界面配置 5 3.1. 准备 5 4. 常用命令 6  初始化信息 在启动交换机后，会有类似如下的信息显示： ---- System Admin Account Setup ---- Enter the password for admin: 输入admin管理员密码，系统设为P@ssw0rd Confirm the password for admin: 再次输入admin管理员密码，P@ssw0rd ---- Basic System Configuration Dialog ---- This setup utility will guide you through the basic configuration of the system. Setup configures only enough connectivity for management of the system. Please register Cisco MDS 9000 Family devices promptly with your supplier. Failure to register may affect response times for initial service calls. MDS devices must be registered to receive entitled support services. Press Enter at anytime to skip a dialog. Use ctrl-c at anytime to skip the remaining dialogs. Would you like to enter the basic configuration dialog (yes/no): no MDS Switch switch login: admin Password: Cisco Storage Area Networking Operating System (SAN-OS) Software TAC support: /tac Copyright (c) 2002-2005, Cisco Systems, Inc. All rights reserved. The copyrights to certain works contained herein are owned by other third parties and are used and distributed under license. Some parts of this software are covered under the GNU Public License. A copy of the license is available at /licenses/gpl.html. switch# 然后，可以按照类似以太网交换机配置的方法来配置交换机了。 交换机配置 配置交换机管理地址 switch# config t Enter configuration commands, one per line. End with CNTL/Z. switch (config)# switchname switch switch(config)# switch(config)# interface mgmt 0 switch(config-if)# ip adress 08 switch(config-if)# no shutdown interface mgmt 0 表示的是交换机的管理端口。 配置VSAN 接下来配置VSAN switch#config t switch (config)#vsan database switch(config-vsan-db)# vsan 100 switch(config-vsan-db)#end 配置ZONESET switch#config t switch (config)#zoneset name anhuipower vsan 100 switch (config-zoneset)#member ZONE_NAME 把ZONE填加到该ZONESET中 注：在交换机处于正常运行时，如果配置了新的ZONE，并