COAL GAS feasibility report.docVIP

Project Feasibility Report For 20,000Nm3 / H Coal Gasification System KEDA INDUSTRIAL CO. LTD 目 录 1.Project and capacity 1 2.Introduction of the system 1 2.1 Technical Introduction 1 2.2 Technical Flow Chart 2 2.3 De-sulfur technology 3 3.Output and power consumption 3 3.1 Output of the gasification system 3 3.2 Raw coal composition analysis 4 3.3 Materials balance 4 3.4 Consumption 4 4.Fire hydrant and safety 5 5. Environment protection 5 5.1 Air pollution 5 5.2 Sewage treatment 5 5.3 Anti-noise 5 5.4 Solid waste 6 6.Working safety 6 7.Worker arrangement 7 8.Investment estimate 8 9. Cost calculation 9 10. Conclusion 9 1.Project and capacity The land area is about 9,398 M2 required for this project, the coal gas capacity is 20KNm3/h, lower heat value of coal gas: ＞100kcal/Nm3 . The main machine list is showing as below: Main machine list Description Qty Remark Raw coal deposited and conveying system 1 set 10kNm3/h Coal gasification stove 2 sets Two running and one stand by Desulphurization system 1 set Gas storage tank 1 set Compression station 1 set (3 pcs) Two running and one stand by Gas pipeline 1 set It needs about 10 months from the contract signing date to complete the project, the single stove capacity can reach 10kNm3/hour, the heat value is 4.6 MJ/Nm3 (1100 Kcal /Nm3). The general layout please refers to the attached drawing. 2.Introduction of the system NEWPOWER coal gasification system is developed from Cycling Fluid Bed Gasification (CFBG) technology. It utilizes the air to fluidize the coal powder in the gasifier bed for combustion; the coal powder combustion is circulating inside/outside the gasifier. Compare with the traditional coal-gas system, the NEWPOWER system advantage is low pollution, can be suitable for different kinds of coal, higher efficiency of carbon converting. New-power clean gasification system includes desulphurization system, compression system, DCS operation system and water treatment