Coil Modeling M6R305.pdfVIP

with Infolytica Corporation May 25, 2000 We welcome your comments regarding Infolytica Corporation documents. Please send comments or corrections to the following addresses: email: docs@ fax: Documentation Department 514.849.4239 post: Documentation Department Infolytica Corporation P.O. Box 1144 Station Place du Parc Montreal, Quebec H2W 2P4 Canada © Copyright 2000, Infolytica Corporation. Part number M6R305. All rights reserved. No part of this document may be reproduced, translated to another language, stored in a retrieval system, or transmitted in any form or by any means, electronic, photocopying, recording, or otherwise, without written permission from Infolytica Corporation. The information in this document is subject to change without notice. Table of Contents Introduction to coils in 2D models . . . . . . . . . . . . . . . . 1 2D translational geometry 1 2D rotational geometry 1 Direction of positive current flow 2 Choosing the direction of current flow . . . . . . . . . . . . . .2 Create a coil by selecting component surfaces 3 Create a coil by selecting components 4 Changing the direction of current flow . . . . . . . . . . . . .5 Coil page 5 Reverse the direction of current flow 5 Coil property page 6 Introduction to coils in 3D models . . . . . . . . . . . . . . . . 7 Creating coils 8 Create a coil by selecting a component 8 Create a coil by selecting a surface of a component 8 Editing the properties of a coil 9