储罐内衬混凝土施工方案.docVIP

白液贮存槽内衬混凝土施工方案 White Liquor Storage Tank Lining Concreting Program 1.施工前的检查 Checking before Construction （1）储罐的组对和焊接完成后，对储罐的外观进行检查，按照《立式圆筒型焊接油罐施工及验收规范》GB50128-2005的储罐的焊缝、垂直度和圆度进行复查。After completing the pairing and welding of the storage tank, check the outlook of the tank, and review the welds, the verticality, and the roundness of the tank in accordance with GB50128-2005 the “Construction and Acceptance Specification for Vertical Cylindrical Welded Oil Tanks”. （2）对储罐底板焊缝进行抽真空检查。Make vacuuming checks for the welds on the bottom of the tanks. （3）对储罐进行盛水试验检查。Check the tanks by filling water. （4）检查储罐的管道接口和人孔门是否施工完成。Check whether the construction of the piping interfaces and man-holes of the tanks is completed. 2.白液贮存槽内衬混凝土施工White liquor storage tank lining concrete construction 2.1施工前的准备工作Preparations before construction 2.1.1储罐壁板钩钉的焊接 Welding the tank wall hooks （1）在储罐壁板用φ20mm的螺纹钢弯制成的钩钉焊接，壳体部分每平方米6个钩钉。如图1-1：On the wall of the tanks, weld with hooks made by bendingφ20mm rebar, using 6 hooks for each square meter of the shell body, see Fig. 1-1: （2）在完成盛水试验后，用钢丝轮对壁板进行除锈，要求罐壁内表面无可见的油脂和污垢，并且没有附着不牢的氧化皮，铁锈后油漆涂层等附着物，壁板表面应显示出金属光泽，达到手工除锈的St2级标准。After completing the filling-water test, de-rust the wall plates with steel wire wheels, requirements: no grease or dirt visible on the interior surface of the tank wall, no oxidized skin that does not attach fast, or other attachments resulting from painting on rust, and the surface of the wall plate should shine with a metallic luster, reaching ST2 standard for manual de-rusting. (3)在罐内壁铺设100*100*4mm钢丝网，用扎丝固定在已焊接好的钩钉上。如图1-2所示：Lay 100*100*4mm steel wire net on the interior wall of the tank, use thin binding wire to fix on the welded hooks. See Fig 1-2: 2.1.2模板施工 Mould plate construction 用1000*160mm的模板沿储罐内侧进行施工，保证模板与储罐内壁之间的间距为80mm;钢模板内侧用DN40的架管进行加固和支撑。如图1-2和1-3. Use 1000*160mm mould plate for construction inside the tanks, make sure that the spacing between the mould plate and the inner wall of the tanks is 80mm; inside the steel m