《FX-2AD》.pdfVIP

FX-2AD-PT SPECIAL FUNCTION BLOCK USERS GUIDE JY992D55701A This manual contains text, diagrams and explanations which will guide the reader in the correct installation and operation of the FX-2AD-PT special function block and should be read and understood before attempting to install or use the unit. Further information can be found in the FX PROGRAMMING MANUAL and FX/FX2C SERIES HARDWARE MANUAL. The FX-2AD-PT analog block amplifies the input from two platinum temperature sensors (PT 100, 3 wire, 100 Ω) and converts the data into 12 bit readings stored in the Main Processing Unit (MPU). Both Centigrade (°C) and Fahrenheit (°F) can be read. Reading resolution is 0.2°C/0.36°F. All data transfers and parameter setups are adjusted through software control of the FX-2AD-PT ; by use of the TO/FROM applied instructions in the FX PC. Note : FX programmable controllers versions 2.0 or later (those with serial number 13 or larger) are required as these units have the TO/FROM applied instructions in their instruction set. All FX2C Models may be used. The FX-2AD-PT occupies 8 points of I/O on the FX expansion bus. The 8 points can be allocated from either inputs or outputs. The FX-2AD-PT draws 30mA from the 5V rail of the MPU or powered extension unit. Weight : Approx. 0.5kg (1.1 lbs) Dimensions : mm (inches) M3.5 (0.14) 24V LED Mounting holes terminal screws A-D LED 5.5mm (0.27) dia. Any connection to these terminals