《11172-3 mp3协议》.pdf

TITLE PAGE PROVIDED BY ISO CD 11172-3 CODING OF MOVING PICTURES AND ASSOCIATED AUDIO FOR DIGITAL STORAGE MEDIA AT UP TO ABOUT 1.5 MBIT/s Part 3 AUDIO CONTENTS FOREWORD INTRODUCTION 1. GENERAL NORMATIVE ELEMENTS 1.1 Scope 1.2 Organization of the Document 1.3 Normative References 2. TECHNICAL NORMATIVE ELEMENTS 2.1 Definitions 2.2 Symbols and Abbreviations 2.3 Method of Describing Bitstream Syntax 2.4 Requirements 2.4.1 Coding Structure and Parameters 2.4.2 Specification of the Coded Audio Bitstream Syntax 2.4.3 Semantics for the Audio Bitstream Syntax 2.4.4 The Audio Decoding Process 2.4.5 Compliance Requirements 3-Annex A (normative) Diagrams 3-Annex B (normative) Tables 3-Annex C (informative) The Encoding Process 3-Annex D (informative) Psychoacoustic Models 3-Annex E (informative) Bit Sensitivity to Errors 3-Annex F (informative) Error Concealment 3-Annex G (informative) Joint Stereo Coding FOREWORD This standard is a committee draft that was submitted for approval to ISO-IEC/JTC1 SC29 on 22 November 1991. It was prepared by SC29/WG11, also known as MPEG (Moving Pictures Expert Group). MPEG was formed in 1988 to establish a standard for the coded representation of moving pictures and associated audio stored on digital storage media. This standard is published in four parts. Part 1 - systems - specifies the system coding layer of the standard. It defines a multiplexed structure for combining audio and video data and means of representing the timing information needed to replay synchronized sequences in real-time. Part 2 - video - specifies the coded representation of video data and the decoding process required to reconstruct pictures. Part 3 - audio - specifies the coded representation of audio data. Part 4 - conformance testing - is