ET155详解.pptVIP

ET155 – Protection 现役网中ET155的标准配置如下：注意：五条DL3链必须连到同一个TSB4板上 SSR8_4_Byb501 * SS R8.0 Feature ET155 SUBSNT 1 LOT 1 EM=1 Dev 0 - 511 DL3 DLBUS SNTINL 0-15 相当于SNTP 0-15 DL3 DLBUS SNTINL 16-31 DL3 DLBUS SNTINL 32-47 DL3 DLBUS DL3 DLBUS SNTINL 48-62 SUBSNT 6 HOT备用 EM=6 Protection SUBSNT 0 HOT EM=0 SDH 155 Mbit /s (MSP1+1) SUBSNT 2 LOT 2 EM=2 Dev 512-1023 SUBSNT 3 LOT 3 EM=3 Dev 1024-1535 SUBSNT 4 LOT 4 EM=4 Dev 1536-2015 SUBSNT 5 LOT EM=5 Protection Student Text page 94 TSB4 DL3 DL3 DL3 DL3 DL3PN RP Definition for ET-155 - (1)  In the above example we have eight RP4s to support four ET-155s, each magazine contains two ET-155s and we shall have 2 magazines RP Definition - (2) EM Definition EM numbering is fixed to the equipment number within one particular ET-155: EM=0 is always the Working HOT card, EM=4 are the specific LOT cards, EM=5 for LOT protection card (if required) and EM=6 is HOT protection card. The EM numbering follows the physical location of the cards within the ET-155 subrack from Left-to-Right. SNT connection to Group Switch EQLEV - equipment level in SNT (1-4) 1=LOT-2 to 4 are not valid, Only LOT-1 valid 2=LOT-1 and LOT-2 are valid 3=LOT-1, LOT-2 and LOT-3 are valid 4=all LOT cards are valid PROT - protection level, type of protection to use (0-3) 0=No protection 1=LOT protection only - EM=5 must be defined 2=HOT protection only - EM=6 must be defined 3=LOT and HOT protection - EM=5 6 must be defined SNT Position (SNTP) defines the TSM followed by 1st internal connection point, eg; EQLEV=4 means lot1,lot2,lot3,lot4 will connect to GS by DL3 bus; PROT=3 means lot5 and hotb serve as protection card. The TSM 24,25,26,27 are for et155-0,the TSM 28,29,30,31 are for et155-1,and so on. Connection of Devices to SNT (1) To be continued……... Connection of Devices to SNT (2) Note: The command format for et155 device is not same as common device .e.g. RBLT . There can be several device types used