LED汉字显示屏论文—毕业设计论文说明书.doc

基于无线传输的汉字显示屏 的设计 The design of the Chinese characters display based on wireless transmission 学 院：信息科学与工程学院 专 业/班 级：通信工程0701班 学 号：070404024 学 生 姓 名： 指 导 教 师：曾一凡 （教授） 2011 年 6 月 摘 要 本文的主要内容是基于单片机AT89C51控制无线传输的LED点阵汉字显示屏设计的实现。它主要依靠于AT89C51来控制，并用一些外围驱动电路来驱动LED点阵进行显示。利用AT89C51单片机本身强大的功能，可以很方便的实现单片机与PC机间的数据传输及存储，并能利用软件方便的进行显示内容的各种变化，另一方面点阵广告屏广泛的应用于医院、机场、银行、学校、出租车等场所，所以汉字显示屏的设计现实中具有很强的应用性。所选用的AT8951单片机单片机的可擦除只读存储器可以反复擦除1000次除此之外，单片机I /O口4个16×16点阵汉字。利用74HC595 这款8位串行输入/输出移位寄存器PC机与单片机之间的通信采用RS2通信标准来实现。关键字：；LED点阵显示；Abstract The main content of this article is based on microcontroller AT89C51 and wireless transmission of LED dot matrix characters display design realization. It is mainly depend on AT89C51 to control. And some peripheral drive circuit to drive of LED dot matrix displayed. AT89C51 itself has powerful functions, can easily achieve between microcontroller and PC the data transmission and storage, and can use software convenient to display the content of various changes, On the other hand LED advertising screen is widely used in hospitals, airports，banks, schools, taxies, these places so the design of Chinese characters is in reality display strong applied. AT89C51 microcontroller chosen is because of the low cost but highly efficient micro-controller, MCU EEPROM can be erased repeated 1000 times. And the program easy to write, making the whole system of inspection, maintenance and repair is also very simple. . In addition, the design of microcontroller I / O ports occupy small, easy to extend the function of the system. The LED display design is based on serial transmission of data, dynamic scan method for simultaneous display four 16 × 16 dot matrix characters. The use of 74HC595 8-bit serial input / output shift register to transmit, store data. Use ULN2803 chip to drive of LED dot matrix. Host computer through the PC software to modify the display and the display and so on.。The communication between PC and the microcontroller using RS422 commu