交流电弧炉SVC装置2次滤波支路设计校核新方法.pdfVIP

第42 卷 第1 期 电力系统保护与控制 Vol.42 No.1 2014 年1 月1 日 Power System Protection and Control Jan.1, 2014 交流电弧炉SVC 装置2 次滤波支路设计校核新方法 1 2 1 1 2 2 段晓波 ，朱明星 ，胡文平 ，戎士洋 ，钱辰辰 ，韩 冰 （1.国网河北省电力公司电力科学研究院，河北 石家庄 050021；2.教育部电能质量工程研究中心，安徽 合肥 230601） 摘要：交流电弧炉不仅属于典型的谐波污染源、闪变发生源，而且交流电弧炉冶炼过程在 2次附近产生较大的间谐波分量。 基于某实际钢铁公司交流电弧炉谐波发生量和SVC装置参数的定量分析及仿真研究，得到交流电弧炉必须设置2次C 型滤波 器，保证将电弧炉2 次左右的谐波和间谐波放大控制在一定范围内的研究结论。在此基础上给出 2次滤波支路的设计方法， 提出了2 次滤波支路安全校核新方法，指导交流电弧炉滤波装置工程设计。 关键词：交流电弧炉；谐波和间谐波；静止无功补偿器；2次C 型滤波器；安全校核 Research on the design and check method of the secondary filter branch for SVC device of the AC arc furnace 1 2 1 1 2 2 DUAN Xiao-bo , ZHU Ming-xing , HU Wen-ping , RONG Shi-yang , QIAN Chen-chen , HAN Bing (1. State Grid Hebei Electric Power Research Institute, Shijiazhuang 050021, China; 2. Power Quality Engineering Research Center of Ministry of Education, Hefei 230601, China) Abstract: The AC arc furnace is a typical pollution source of harmonic wave as well as a flicker source. It also produces larger inter-harmonic component during working near secondary harmonic. This paper analyzes and simulates the harmonic quantity and the parameters of SVC device of the arc furnace in a steel company. The conclusion shows that it is better to install the secondary filter of type C for the arc furnace in order to limit the harmonic and interharmonic near secondary. A new checking method is put forward for the secondary filter branch, which is a good method that can