数控技术专业英语 作者 刘瑛 12.pptVIP

5．If we enter a value of 0.400 into the register, then the control thinks that the cutting tool is smaller than it actually is, and it moves the tool closer to the workpiece. 如果我们把数值0.400输入寄存器，那么控制器就会认为刀具比实际的要小，这样它就会将刀具移动得离工件更近。 12.6.2 Lead In and Out with Tool Radius Compensation a Illegal b legal Cutter compensation cannot be initiated with circular interpolation a. Use a linear move to the start of the arc to initiate compensations and then program the path to the tangent points.（b刀具补偿不能由圆弧插补a产生。应该先用一个指向圆弧起点的直线运动来产生补偿，然后再开始用切点坐标进行编程b。）Figure 12.14 Vocabular