ProductName-PharosProject.docVIP

MATERIAL SAFETY DATA SHEET This document has been prepared to meet the requirement of the U.S. Osha Hazard communication Standard 29 CFR 1910, 1200 and Regulatory requirements. 1. Company Product Identification Product Name : DEKODUR METAL LAMINATEManufacturer : Dekodur GmbH bCo.7KGHeat Office : Langenthaler Stra?e 4, 69434 Hirschhorn, GermanyPhone: : +49 (0) 6272 689 0Fax : +49 (0) 6272 689 30Web : www.dekodur.deEmail : info@dekodur.deEmergengy Assistance: Please contact above Head Office 2. Composition / Information of Ingredients A simple substance or a mixed composite : a mixed compositeFor 0,80 mm high pressure laminate Ingredient Name Melamine resin cured substance Phenolic resin cured substance Papercellulose Aluminiumalloy Copper Stainless steel Content - 24-30 45-57 31-13 31-13 31-13 CAS No. 108-78-1 9012-45-7 9004-34-6 7429-90-5 7440-50-8 12597-68-1 Especially for stainless steel products (18/8 stainless steel; 1.4301 ; UNS - S30400) This Product according to RoHS requirements. For values see table below: AISI C max SI max Mn max Cr. Ni 304 0.08 1.00 2.00 17.5-20 8-10.5 3. Hazards Identification Overview Hazardous influence on human health : be cautious of the dust generated on maching the product. Environmental effect : Little Physical Chemical charateritics : Physical Chemical stable at normal conditions 4. First Aid Measures Inhalation : In case the dust generated on processing or treating the product is inhaled, gargle with fresh water for remival. Consult a doctor if necessary. Skin : In Case the dust generated on processing or treating the product is adhered to skin, wash it with soap and fresh water. Consult a doctor if necessary Eye contact : In case the dust generated on processing or treating the product entered into eyes, flush with plenty of water for at least 15 minutes. Contact a medical doctor if necessary. Ingestion : In Case the dust generated on processing or treating the product is inges