POStyleAirClutch-WPTPowerCorporation.PDFVIP

PO STYLE AIR CLUTCH INSTALLATION AND MAINTENANCE MANUAL WPT Power Corporation 1600 Fisher Road - Wichita Falls, TX 76305 P.O. Box 8148 - Wichita Falls, TX 76307 Ph. 940-761-1971 Fax 940-761-1989 www.WPT WIM-PO-001_E Page 1 of 12 SECTION 1 INTRODUCTION GENERAL INFORMATION An assembly drawing and bill of material sheet is provided with each unit shipped from our factory. If these are not available, they may be obtained from WPT Power Corporation or one of its authorized stocking distributors found worldwide. Order parts from your nearest WPT Power Corporation distributor. In most cases, they will have the commonly needed parts ready for shipment. The illustrations found in this manual refer to this manual only and not specifically to your clutch. Consult the assembly drawing for your model clutch when ordering parts. When ordering replacement parts, proceed as follows: 1. Provide the assembly number of the clutch as found on the stamped nameplate. Provide the item number of the part from the bill of material, the description of the part, and the quantity required. 2. Furnish the complete shipping destination and physical address. All parts sales are made through the distributor network. State specifically how the parts are to be shipped. If not advised, the equipment will be shipped the best way, considering time and expense. SCOPE This publication provides the information necessary for the operation and maintenance of the WPT Power Corporation equipment specified on the cover of this manual. Specific engineering details and performance characteristics can be obtained from WPT Power Corporation or one of its authorized distributors. Operation and maintenance personnel responsible for this equipment should have thi