Powerpoint-Clutch-1.pptVIP

Clutch Replacement Inspection Clutch Replacement Inspection Clutch Replacement Inspection Clutch Replacement Inspection Clutch Replacement Inspection Clutch Replacement Inspection Clutch Replacement Inspection Clutch Replacement Inspection Clutch Replacement Inspection Clutch Replacement Inspection Clutch Replacement Inspection Clutch Replacement Inspection * Be sure to mark the Pressure Plate to Flywheel orientation. Loosen bolts in sequence 1/2 turn at a time to prevent warpage to Pressure Plate cover. Hold Pressure Plate assembly in position while removing bolts. Remove Pressure Plate assembly and Clutch disc as a unit. Be careful not to allow the Clutch Disc to slide out and fall on the floor. Clutch Removal Measure lining thickness from lining to the head of a rivet at thinnest point. Check lining surface for cracks, missing chunks, glazing and oil contamination. Inspect for loose, broken or missing torsion springs. Inspect Clutch Disc Spline for wear and distortion. Place on the Input Shaft to check axial freeplay. Clutch Disc Inspection Inspect Clutch Disc cushion springs for collapsed, cracked or broken cushion springs. Inspect the Pressure Plate surface for overheating (blueing), heat checks, hot spots. Sand surface to determine depth of the defect. Inspect surface for scoring and warpage with a straight edge Feeler Blade. Inspect for broken, cracked or warped Pressure Plate springs. Pressure Plate Cover Inspection Inspect diaphragm spring fingers for bending, cracks or uneven wear at the Release Bearing contact point. Measure thickness of release fingers at Release Bearing contact point. Replace if under specification. Pressure Plate Cover Inspection Inspect the Clutch Disc contact surface for overheating (blueing), heat checks, hot spots and glazing. Sand surface to determine depth of defect. Inspect the friction surface for scoring and warpage with a straight edge Feeler Blade. Flywheel Inspection Some Flywheels can be ground to