Tools_specs_2011.doc-KenyaPower.docVIP

TECHNICAL SPECIFICATIONS THE KENYA POWER AND LIGHTING CO. LTD. SPECIFICATION for DISTRIBUTION NETWORK OPERATION TEST EQUIPMENT AND TOOLS REVISION RECORD REVISION DESCRIPTION OF REVISION DATE APPROVAL 0 1ST ISSUE June 2006 1 June 2009 CONTENTS Foreword Scope Service Conditions Measuring wheel for cable route length Cable Pulling stockings Cable Peeling and stripping tool Phase Rotation Meter Cable Rollers Cable corner Rollers 11KV Live Line Tester Indoor 66Kv Live Line Tester 66Kv Phasing Out Sticks Earth Resistance measuring Instrument Multimeter Hand compression tool 300mm2 Pull Lift 1.5 Ton Mini Ratchet Puller 1 Ton Wire cutter 24” Wire Cutter 36” Come along clamps Line Inspection Binoculars Fibre sling 3 Ton Clip on ammeter 11kv Line inspection LED Rechargeable flashlight D Shackles Infrared camera outdoor Infrared camera indoor Hand compression tool 16mm2 to 75mm2 Cable spiking Gun Portable Earthing Harness Spares Accessories Calibration  FOREWORD This specification has been prepared by the Research and Development of KPLC. It lays down requirements for Distribution Network Operation Test Equipment. This specification is intended for procurement of equipment and does not include provision of contract. It is subject to revision as and when required. SCOPE This specification is for testing equipment Tools used in the distribution network. SERVICE CONDITIONS The equipment shall be tropicalised, designed and constructed for continuous indoor and outdoor operation in areas with the following atmospheric conditions:- Altitude: From sea level up to 2000m above mean sea level. Humidity: High at the Coast, up to 90% and lower inland, up to 50%. Temperatures: Average ambient of +30 ? C with a minimum of -1°C and a maximum of +40 ? C. Pollution: Heavy saline with severe corrosive effects in coastal lands and generally clean air inland. Isoceraunic levels: Low in the coastal are