流量计毕业论文涡轮流量计标定装置及测量电路设计.doc

涡轮流量计标定装置及测量电路设计 学 院 航空航天工程学部 专 业 班 级 学 号 姓 名 指导教师 负责教师 沈阳航空2014年6月摘 要 关键词：；；； design Abstract With the development of the fluid system to the direction of miniaturization, the demand for accurate measurement of small flow becomes more and more. This paper presents the design of a small range of flow meter . the calibration test and the design of the sensor conditioning, it has high accuracy, easy to use, adaptable, and converted to a digital signal output of the advantages of easy identification square wave . The article is mainly designed tangential turbine flow-meter, As well as the design of the cutting simulation and PCB design after the flowmeter sensor conditioning circuits .while adjusting the speed of the turbine installation stepper motor for a detailed description.and in accordance with the principle and implementation method for measuring small flows, improved measurement system. Measurement system on the basis of the liquid flow standard device to improve the regulator device, using the method of regulator overflow weir; Designed a new liquid weighing container - double sets of measuring cups weighing the container; The selection of a higher measurement accuracy electronic balance, replacing the commonly used leveraged balance, the measurement is more simple and accurate. According to the characteristics of micro flow measurement, this article selection of the dynamic quality of the principle of flow calibration which simplifies the measurement process, reduces cost and improves the measurement accuracy, to prove that its design is feasible. Keywords: Tangential turbine flow-meter; Liquid flow standard device; Dynamic Quality Act; Flow calibration ;Signal condition circuit;Stepper motor regulation;PCB printed circuit board 目 录 1 绪论 5 1.1 研究的背景、目的和意义 5 1.2 本课题研究的主要内容、技术路线及需解决的技术关键 5 1.2.1 研究的指导思想 8 1.2.2 主要研究内容、技术关键与难点 8 2 小量程流量计的选择及设计 10 2.1 涡轮流量计概述 10 2.1.1 涡轮流量计发展概况 10 2.1.2 涡轮流量计的特点 11 2.2 切向式涡轮流量计 12 3 试验系统的建立与选择 17 3.1