基于限流器本体信号的短路故障快速识别方法.pdfVIP

第 36 卷 第 11 期 电 网 技 术 Vol. 36 No. 11 2012 年 11 月 Power System Technology Nov. 2012 文章编号：1000-3673 （2012 ）11-0247-05 中图分类号：TM 771 文献标志码：A 学科分类号：470·4054 基于限流器本体信号的短路故障快速识别方法 赵永熹，王华昕 （上海电力学院电力与自动化工程学院，上海市 杨浦区 200090 ） Rapid Fault Identification Method Based on Body Signal of Fault Current Limiter ZHAO Yongxi, WANG Huaxin (School of Electric Power and Automation Engineering, Shanghai University of Electric Power, Yangpu District, Shanghai 200090, China) ABSTRACT: Fault current rapid identification is the key of 时电容器被快速旁路，相当于投入电抗器，从而达 series resonant fault current limiter (SRFCL) control strategy. 到限流目的。短路故障识别是限流器快速触发策略 The paper introduces resonant voltage difference method based 的关键环节，电容器快速旁路动作速度决定了限流 on the theory which voltage difference of SRFCL resonant 器的投入速度[1-6] 。关于故障识别方法国内外有许多 component will mutate at fault. Time characteristics are analyzed on the parameters of the closing angle and fault 研究成果。传统保护算法由于计算电流基波分量， distance. Fast trigger system based on programmable [7] 滤波时间窗口过长，不满足限流器快速性的要求 。 technology is built and the speed of method is verified by 电流行波穿越串联电抗器的能力非常弱，不适用于 model test. Simulation results show that the method has good [8] 限流器故障检测 。文献[9-10]介绍了串补工程上采 response and is not affected by fault parameters, but it is 用的短路电流瞬时值和电流微分率方法。电流幅值 interfered with the breaker close and open. So it should