亚临界及近临界压力区低质量流速垂直内螺纹管传热特性试验研究.pdfVIP

  • 4
  • 0
  • 约3.63万字
  • 约 7页
  • 2016-03-10 发布于湖北
  • 举报

亚临界及近临界压力区低质量流速垂直内螺纹管传热特性试验研究.pdf

亚临界及近临界压力区低质量流速垂直内螺纹管传热特性试验研究.pdf

第 30 卷 第 11 期 中 国 电 机 工 程 学 报 Vol.30 No.11 Apr.15, 2010 2010 年 4 月 15 日 Proceedings of the CSEE ©2010 Chin.Soc.for Elec.Eng. 79 0258-8013 (2010) 11-0079-07 TM 85 A 470 20 文章编号: 中图分类号: 文献标志码: 学科分类号: ⋅ 亚临界及近临界压力区低质量流速 垂直内螺纹管传热特性试验研究 潘杰,杨冬,朱探,董自春,毕勤成 (动力工程多相流国家重点实验室(西安交通大学) ,陕西省 西安市 710049) Experimental Investigation on Heat Transfer Characteristics of Vertical Rifled Tube at Low Mass Flux Under Subcritical and Nearcritical Pressure PAN Jie, YANG Dong, ZHU Tan, DONG Zi-chun, BI Qin-cheng (State Key Laboratory of Multiphase Flow in Power Engineering (Xi’an Jiaotong University), Xi’an 710049, Shaanxi Province, China) ABSTRACT: Within the range of pressure from 12 to 21MPa, 内壁热流密度q=132~663 kW/m2 。试验得到了不同工况下垂 mass flux from 232 to 773 kg/(m2 ·s), and inner wall heat flux 直上升内螺纹管的壁温分布特性,分析了压力、内壁热负荷 from 132 to 663 kW/m2, an in-depth experiment was conducted 和质量流速变化对内螺纹管传热特性的影响,探讨了传热恶 at low mass flux to investigate the flow boiling heat transfer 化的发生机制,并给出了能用于工程实际的传热试验关联 characteristics of steam-water in vertical upward rifled tube. 式。试验结果表明:在亚临界及近临界压力区,垂直上升内 The rifled tube is φ32 mm×6.3 mm SA–213T12 carbon steel. 螺纹管会发生第 2 类传热恶化——干涸(dryout),而在试验 The tube wall temperature distribution was obtained in the 中未观测到第 1 类传热恶化——膜态沸腾(departure from experiment. The effects of pressure, inner wall heat flux and nucleate boiling ,DNB) 。压力与内壁热负荷的增大,以及质 mass flux on heat transfer were analyzed, the heat transfer 量流速的减小

您可能关注的文档

文档评论(0)

1亿VIP精品文档

相关文档