高处作业安全培训Working at height - En Ch课件.pptVIP

Oyu Tolgoi Site Induction Safety Brief Presenter 介绍 Entry Exit points 紧急出入口 Muster point 紧急集合点 Muster warden Toilets 洗手间 Breaks 休息 Walkways ramps 走道斜坡 Open sides edges 開放高层及边缘 Holes 孔 Concrete forms rebar 模板及钢筋 Excavations 開挖 When Fall Protection Is Needed 什么时候需要防坠落保护 Sides and edges improper guarding 边緣及角落- 不完整的保护 Good Work Practices 好的工作习慣 Perform work at ground level if possible 尽可能的在地面上工作 Example: building prefab roofs on the ground and lifting into place with a crane 例如: 建築物的屋頂可事先在地面預制然后再用吊車安裝 Tether or restrain workers so they can‘t reach the edge用栓繩或其他方式防止工作人員接近边緣 Designate and use safety monitors (This is less desirable of all the systems) 指定观护人 Use conventional fall protection 养成使用坠落防护的习惯 If you can fall more than 6 feet, you must be protected 如果你有可能自1.8米高以上的地方坠落,你必須要有保护 Use fall protection on: 在下列地方使用墜落防护: walkways ramps, open sides edges, holes, concrete forms rebar, excavations, roofs, wall openings, bricklaying, residential construction 走道及斜坡, 放边缘及角落、孔、模板、屋頂、开放墙边, 砌砖、工程建築 Protective measures include guardrails, covers, safety nets, and Personal Fall Arrest Systems 防护方式包括护栏、蓋板、安全网及人員墜落捕捉系統 Working at Height高处作业 Working at height 高处作业 Fall in construction 施工中的高空坠落 Falls are the leading cause of deaths in the construction industry. 在工程制造這個行业里造成死亡意外最多的就是坠落 Most fatalities occur when employees fall from open-sided floors and through floor openings. 大部分的死亡意外都是發生在开放楼层及開口楼板。 Falls from as little as 1.2 to 1.8 m can cause serious lost-time accidents and sometimes death. 即使是由1.2m到1.8m高的摔落也都會造成严重的失能傷害甚至死亡 Open-sided floors and platforms 1.8m or more in height must be guarded. 開放楼层及工作平台若超過1.8m高必須要有所防护 This presentation will discuss: 我們将讨论: The working conditions that prompt use of fall protection 那些情况我们需要防坠落保护 Options that are available to protect workers from falls 那些设备可以保护人员防坠落 At the end of this topic, you will be able to: 這個課程結束後您將能: List at least four methods of fall prot