08-05MagneticParticalExaminationProcedure磁粉检验工艺规程讲解.doc

Magnetic Particle Examination Procedure 磁粉检验工艺规程 Prepared By编制: Date日期: Reviewed By审核: Date日期: Approved By批准: Date日期: CERTIFICATION 演示证实声明 This is certified that this procedure has been demonstrated to the satisfaction of the Authorized Inspector in accordance with the requirements of T-150 of Section V. 本规程已按ASME规范第Ⅴ卷T－150的要求，在带缺陷试板上进行了演示。演示结果得到了AI的认可。 Certified by Date Ⅲ级证明人： 日期： Witnessed by Date 授权检验师： 日期： Scope 范围 This procedure is applied to the magnetic particle examination of ferromagnetic materials and welds for ASME Code items. 本规程适用于ASME规范产品铁磁性材料和焊缝的磁粉检验。 The magnetic particle examination method is suitable for detecting cracks and other discontinuities on or near the surface in ferromagnetic materials. 磁粉探伤方法适用于检测铁磁性材料表面或近表面裂纹及其它不连续性。 This procedure is applied to wet continuous magnetization by Yoke. 本规程适用于磁轭湿粉连续磁化法。 This procedure shall be demonstrated to the satisfaction of the AI prior to implementation. When construction Code specified, a change of a requirement in Appendix I identified as an essential variable from the specified value, or range of values, requalification of this procedure shall be required. When a change of requirement in Appendix I identified as an nonessential variable from the specified value, or range of values, requalification of this procedure is not required. All changes of essential or nonessential variables from the value, or range of values, specified by this procedure shall require revision of, or addendum to, this procedure. 本规程应按照ASME规范第Ⅴ卷T-150的要求向AI做演示证明。当规定了规程鉴定时，附录Ⅰ中重要变素规定值的变更引起所要求的变化，本规定应重新鉴定。对于非重要变素规定值或数值范围的变更引起的要求变化，本规定不需要重新鉴定。所有重要变素或非重要变素数值或数值范围的改变，应修订增补进本规程。 Personnel 人员 The NDE personnel who engage in magnetic particle examination shall be qualified and certified according to CCIEI Written Practice for Qualification and Certification of Nondestructive Examination (NDE) Personnel based on the requir