大连东软信息学院大一上电子工程c语言-实验.第一次,第二周！.docVIP

Lab 1 Getting Started with C Programming in TurboC OBJECTIVES After completing this experiment, you will be able to: code C programs in TurboC compile and run C programs in TurboC save C programs in TurboC load C programs into TurboC build a simple C program in TurboC debug simple C programs in TurboC use hot keys of TurboC PROCEDURES PART 1 Code a C Program 1. Run TurboC Development Environment. 2. Use [File]([New] to open a new file. 3. Edit a C program as follows: #include stdio.h main() { int a,b; a = 251; ?? b = 8; printf(%d\n, a*b); } PART 2 Compile and Run a C program 1. Press Ctrl and F9 keys at the same time to compile and run a C program. If error occurs, modify the program, compile and run it again. 2. Press Alt and F5 keys at the same time to switch to the user screen to get the result. If the result is not 2008, modify the program, compile and run it again. TIP：Press Esc key to return to the edit screen. Print Screen of Result: [1 mark] —————————————————— PART 3 Save a C program 1. Press F2 key to save a C program. 2．In the input box shown below, input a file name with .c extension (e.g. first.c). 3. Press Enter key to save the file. PART 4 Load a C program 1. Press F3 key to load a C program in the default path of TurboC, e.g. C:\DISK_C\TC20\, D:\turboc2\. 2. Input the program name (e.g. first.c) to be loaded in the input box. 3. Press Enter key to load the file. If error occurs, check the file name and check the default path to make sure whether the name is right and the program is over there. What is the default path of the TurboC in your computer? [1 mark] 棗棗棗棗棗棗棗棗棗 PART 5 Build a C program . PART 4Create a C program that displays your student id and name (Pin Yin) on the screen. Make differences by using Escape Sequence in table 1.2 in page 11, e.g. \n, \t, etc. 1. Write the C program. Print Screen of Code: [6 marks] 棗棗棗棗棗棗棗棗棗 2. Save it using .c extension. 3. Compile and run it using Ctrl and F9 keys. 4. Check r