SMC总线相关产品-new教程分析.ppt

* No plan for developing CE Plug-in connector - No possibility for getting a patent (publicly well known) There is a pattern for wiring (Not applied for a patent) Tie rod (stock type) (Not applied for a patent) (Same as usual) How about multi connector? It is possible to develop in the future. * No plan for developing CE Plug-in connector - No possibility for getting a patent (publicly well known) There is a pattern for wiring (Not applied for a patent) Tie rod (stock type) (Not applied for a patent) (Same as usual) How about multi connector? It is possible to develop in the future. * No plan for developing CE Plug-in connector - No possibility for getting a patent (publicly well known) There is a pattern for wiring (Not applied for a patent) Tie rod (stock type) (Not applied for a patent) (Same as usual) How about multi connector? It is possible to develop in the future. * * * * * * * * Point: Compared with the existing IP67 rated SI unit, around 70% width reduction has been achieved. * Points: In order to allow bus cabling without a branch connector, all PROFIBUS, EtherCAT and DeviceNet SI Units are equiped with dual bus connectors (BUS IN and BUS OUT) When using DeviceNet, in order to avoid causing a disruption of the downstream devices when replacing a SI unit, utilize a DeviceNet tap rather than making connections to the BUS OUT connector. * Points: In order to allow bus cabling without a branch connector, all PROFIBUS, EtherCAT and DeviceNet SI Units are equiped with dual bus connectors (BUS IN and BUS OUT) When using DeviceNet, in order to avoid causing a disruption of the downstream devices when replacing a SI unit, utilize a DeviceNet tap rather than making connections to the BUS OUT connector. * Point: Commonly used M12 connectors for bus and power have been adopted for IP65 and IP67 rated devices. These have advantages over EX124 and EX126 in terms user interface cabling. * Points: Fieldbus variations 3 types (PROFIBUS, EtherC