FanSpeedController精品课件.pptVIP

FSP and FSE Fan Speed Controllers for Air Cooled Condensers Why Condensing Pressure Control? Thermo Expansion valves need a minimum pressure for feed evaporator with sufficient refrigerant At low ambient temperature condensing pressure decreases in air cooled condensers Condensing pressure must be kept at certain level Pressure Control With Pressostat Disadvantage: Condensing pressure fluctuation at normal differential setting Or Life expectancy reduces at small differential pressure setting Continuous Pressure Control Generates constant condensing pressure Product series in past FSX with FSF-N electronic EMC filter cable 2.5/4A, 1 phase ALCO FSX FSX advantages: Compact size Lower cost FSX limitations: Non ideal thermal design due to the heat dissipation of plastic housing Derating @ high ambient temperature Single phase motor only Generally up to 2.5 ALCO FSX vs FSP Temperature degradation The New ALCO Fan Speed Controls Setup The control module contains a pressure sensor Installation location on liquid line Sending control signal (0…10V) to power module Power module contains phase cut control for fan motors Flexible Application I 3 Control Modules for all common refrigerants Control modules from other manufacturer with 0-10V output Flexible Application II Flexible Application III 3 Power Modules for most fan motors 1-phase FSP-150: 5A max. FSP-180: 8A max. 3-phase FSP-340: 3 x 4A max. Connection cables: to mains power: 1,5m to fan motor:0,75m Flexible Application III 3 Control Modules for all common refrigerants Control modules from other manufacturer with 0-10V output Power Modules With Large Capacity Fans can be paralleled up to maximum operating current Full range of fan speed controller FSX with FSO-N cable without electronic EMC 2.5/4A, 1phase FV-142 Series, 8A, 1 phase (Discontinued, May.2004) FSP FSX FSE Control Module FSP-340 Power Module for 3-phase motors up to 4A FSP-1 Power Module for 1-phase motors up to 5A or 8 A FSE-01S FSE-02S FSE-03S