机械毕业设计（论文）-九辊矫正机压下系统设计（全套图纸）.doc

九辊钢板矫正机压下系统设计 摘 要 随着科技的不断发展，我国的轧钢生产技术不断进步。运用轧钢生产技术，可提高轧制产品的质量、减短生产时间、提高成材率、降低生产成本和材料的利用率。但是轧件在轧制、冷却和运输过程中，会受到不同因素的影响，在轧件中产生形状缺陷。例如钢轨、型钢和钢管常出现弧形弯曲；某些型钢的面会产生翼缘内并、外扩和扭转；板材和带材产生横纵向弯曲、边缘浪形和中间瓢曲以及镰刀弯等。为了消除这些缺陷，矫正技术应运而生。根据本次设计的要求，设计了九辊矫正机的压下系统。主要内容包括：九辊矫正机的结构确定、矫正机的力能参数计算、主传动电机和压下电动机的选择及其计算和校核、选择联轴器和设计分配减速器、压下螺丝、压下螺母、蜗轮蜗杆的设计及校核和轴承的寿命计算。 关键词：矫正机；压下系统；力能参数 全套图纸，加153893706 Nine roller plate straightening machine pressure device design Abstract With the continuous development of science and technology, China’s steel rolling production technology progress. Use of steel rolling production technology, improve the quality of rolled piece products, reduce rolling production time, improve yield and lower production cost and material utilization has become a mechanical design of the main goals of steel rolling. But the rolled piece in the process of rolling, cooling and transportation, due to the influence of various factors, often produce shape defect. Columns such as rail, steel and steel pipe often appear arc bending;Some steel shapes creates a flange section inside and outside, expansion and distortion; Plate and strip will produce longitudinal bending, lateral bending, edge wave shape and intermediate ladle and rocker. In order to eliminate these defects, the correction technology emerges as The Times require.According to the design the system of the nine roller plate straightening machine press. The structure of the main contents include: nine roller straightening machine, straightening machine can force parameters calculation, selection and calculation of main motor and motor under pressure and check, coupling and reducer design distribution, pressure of screw, nuts worm gear and worm under pressure design and checking calculation and the design of bearing and life. Keywords: straightening machine;press down system;can force parameters 目录 1.绪论 1 1.1?课题研究的目的和意义 1 1.2矫正机的发展状况 1 1.3辊式矫正机的主要产品、技术性能与工艺参数 2 1.4辊式矫正机的矫正工艺 2 1.5辊式矫正机的工作原理及特点 3 1.6本课题研究内容及方法? 3 2.总方案 5 2.1矫正方案 5 2.2