大学毕业设计英语文献翻译--基于pic单片机的电子控制实验箱的设计与实现.docVIP

南昌航空大学信息工程学院 毕业设计英语文献翻译 摘自 /journal/PaperInformation.aspx?PaperID=22046 专 业 自动化 班 级 090441 学 号 姓 名 龚 亮 指导老师 李军华 日 期 2013 年 3 月 15日 Design and Implementation of Electronic Control Trainer with PIC Microcontroller Yousif I. Al Mashhadany Electrical Engineering Department, Engineering College, University of Anbar, Baghdad, Iraq Email: yousif_phd@ Received April 26, 2012; revised May 23, 2012; accepted May 30, 2012 ABSTRACT This paper describes the implementation of a PIC microcontroller in a conventional laboratory-type electronic trainer. The work comprises software for the PIC and hardware for the software. The PIC controller uses an EasyPIC-6 board and includes a PC-interfaced programmer for the PIC chip. It has many external modules: 128 ?64 graphic LCD dis- play, 2 ?16 LCD display, 4 ?4 keypad, and port expander, all in the same bench. The trainer is capable of 36 experiments in logic/analogue electronic and control systems. A 5-sided approximate sensor, two photoelectric sensors (BR56-DDT-P and BEN9M-TFR),four CMOS,four BCD-7-segment driven by CD4511B, two relays (2-pole and 3-pole), six voltages, ammeter measurement, DC motor, and 24VDC power supply, connect through connectors and pinions. Results of all the experiments show the trainer satisfying requirements of undergraduate and postgraduate pro- jects involving conventional electronic and classical control systems. Keywords: PIC Microcontroller; Photoelectric Sensor; Conventional Electronic Trainer 1. Introduction Modern microcontroller chips can store hundreds of thou- sands of transistors each. The first microprocessors had external peripherals such as memory, input-output lines, and timers (Matic, 2003). In time came a new device called integrated circuit (IC), which contains both processor and peripherals. Also called a microcontroller, this was the first chip with a microcomputer [1,2]. Peripheral In