MBR法处理校园污水设计论文毕业设计讲述.docVIP

学士学位论文 论文题目 院 系 专 业 姓 名 学 号 指导老师 日 期  郑重声明 本人郑重声明：本人所呈交的学位 声明人签名：2015年月日高校是人口居住集中的地方，每天产生大量的生活污水。。因此设计一个合理可行的污水处理系统有十足的意义此处考虑到学校地处市区，土地稀缺，故按实际情况可设计计算一个以MBR生物处理器为核心的生物处理系统。经验表明，经该类似系统处理后，出水水质可达国家杂用水标准。 关键词：生活污水；处理；MBR ABSTRACT College is densely inhabited area where a great amount of sewage is produced. Suppose the per capita domestic water consumption is 150L, mutiply 0.8, the result is 120L, which is the students percapita domestic water consumption. 30,000 students in 250 day would use about 900,000t water, which means 270,000t water may be wasted, therefore its essencial to design a sewage treatment system. According to the actual situation of Hubei Minzu University, a MBR biological treatment system is recommended to design. The system has many features,like high efficiency, small footprint and high effluent standards and so on. Experience has shown that a similar system through which the treated water quality up to the national miscellaneous water standards. The main contents of the design of the grid cell size computing, grid computing to select the size, adjust the size of the pool of computing, regulation pool pump selection, MBR tank size calculation, MBR membrane module selection, MBR Pool Pump Selection , MBR membrane cleaning system design and engineering cost estimates. Key word：sewagetreatment; MBR; calculatestandard; engineering目 录 摘 要 I ABSTRACT II 引 言 1 1绪 论 2 1.1设计任务 2 1.1.1日污水处理量 2 1.1.2目标出水水质 2 1.2设计要求 2 1.3设计依据 2 1.4设计原则 3 2工艺流程说明 4 2.1流程图 4 2.2流程说明 4 2.2.1污水处理说明 4 2.2.2污泥处理说明 4 2.2.3工艺说明 5 3设计计算 6 3.1化粪池 6 3.2格栅 6 3.2.1设计数据 6 3.2.2设计计算 7 3.2.3格栅池参数 10 3.3调节池 11 3.3.1设计数据 11 3.3.2设计计算 11 3.3.3调节池技术参数 12 3.4 MBR池 13 3.4.1膜组件选型 13 3.4.2池体计算 13 3.5曝气鼓风机选择 15 3.5.1曝气量计算 15 3.5.2曝气鼓风机选择 16 3.6膜清洗系统 16 3.6.1清洗示意图 16 3.6.2 MBR膜清洗所需药物 16 3.6.3清洗用泵选择 17 3.6.4膜元件药液清洗操作时中的注意事项