水泵涡壳加使用工工艺夹具设计#40;毕业设计初稿#41;初版.doc

水泵涡壳加工工艺夹具设计 摘要 本课题来源于东风汽车泵业有限公司实际生产需求，主要论述了水泵涡壳的加工工艺及基准B面的加工夹具设计。水泵涡壳的尺寸精度、形状精度及位置精度的要求都比较高。而由于材料的选择,其刚性较差，容易产生形变。因此安排工艺过程时，就要把各主要面的粗精加工工序分开。逐步减少加工余量，以减少切削力、内应力的作用，提高加工精度，缩短生产节拍，满足大批量生产的需要。 关键字：水泵涡壳加工工艺夹具设计  Abstract The subject comes from the actual production needs of Dongfeng Automobile Pump Co,mainly discusses the pump volute process and basis B surface machining fixture design.The requirements of dimensional accuracy,shape accuracy and positional accuracy for the pump volute is high.Due to the choice of material,less rigid,easily deformed.It is imperative to separate rough and finish surface when design process.Gradually reduce the allowance to reduce the role of the cutting force,internal stress,improve processing accuracy,shorten the production cycle to meet the needs of mass production. Key word:pump volute processing fixture design 目录 一、绪论..................................................................1 1.1课题来源、目的、意义...................................................1 1.1.1课题的来源...........................................................1 1.1.2本课题研究目的.......................................................1 1.1.3本课题研究的意义.....................................................1 1.2国内外概况、预测和文献综述............................................ 1.2.1课题的国内外研究概况.................................................2 1.2.2课题的研究趋势预测...................................................3 二、水泵涡壳的工艺性分析..................................................5 2.1水泵涡壳的材料选择....................................................5 2.1.1稳定的显微组织.......................................................5 2.1.2良好的工艺性能.......................................................5 2.2毛坯及制造方法........................................................5 2.3确定毛坯尺寸和公差....................................................6 2.4零件的工艺设计........................................................6 2.4.1基准的选择...................................................