论文——涡轮增压器组件的装配与检测系统设计.docVIP

本科毕业设计（论文） 题目 涡轮增压器组件的装配与检测系统设计 学 院 电气与自动化工程学院 年 级 2011级 专 业 自动化 班 级 自动化113 学 号 160111126 学生姓名 俞雷 校内导师 毛丽民 职 称 副教授 校外导师 朱广海 职 称 应用工程师 论文提交日期 2015-05-12  常熟理工学院本科毕业设计(论文论文esign of Measuring Three-phase Power Factor Angle on Microcontroller Abstract With the acceleration of the process of modernization, Modern societys demand for electricity is gradually increased, the quality requirements for electrical energy is increasing. A mass of power electronics equipments under the new technology input to the daily life. Of course, many of these power electronics equipments will increase reactive power, So that the power factor of the grid will decrease, resulting in reduced quality of power supply. This requires the power factor of the grid is necessary to detect. The measurement circuit of power factor angle based on STC89C52 microcontroller provides convenience to detection. This design uses STC89C52 microcontroller as the control core, uses counters to measure voltage and current phase difference, and finally calculates the power factor in the power grid. In the design process, while the power factor angle of the grid is detected, the frequency of the grid can be detected. Practice has proved that the design of the measurement method is simple and reliable, high precision, and easy to implement. Real-time detection results will be displayed, but also facilitate real-time monitoring. Key words: STC89C52; Power factor angle; Frequency; Real-time monitoring 目录 1.绪论 11 1.1 研究背景 11 1.2 研究内容及发展趋势 11 1.3 研究的主要内容 13 1.4 本章小结 14 2. 方案论证 14 2.1 方案说明 14 2.1.1方案一 14 2.1.2方案二 15 2.1.3方案三 15 2.2 本章小结 16 3.控制核心的选用与介绍 17 3.1 STC89C52单片机介绍 18 3.2计数器介绍 19 3.3中断系统 22 3.4复位电路、时钟电路以及最小系统 22 3.5本章小结 23 4.硬件电路设计 23 4.1 系统总的结构框图 23 4.2 信号采集与输入信号整形电路 24 4.2.1 LM339构成的过零比较器 24 4.2.2 信号采集与信号整形 25 4.3 相位检测