sls音箱线阵厂方培训研讨.pptVIP

* Focus on: wave spreading due to point source drivers Over-lapping wavefront creates phase anomalies and losses Planar has: No point source No spreading No overlapping wavefront * 2000Hz 2000Hz 三个点声源w/ 55.8mm (2.2”) 中心点间距 Three Point sources w/ 55.8mm (2.2”) center-to-center spacing 建立一个线声源 Building a Line Source * 2000Hz 2000Hz 四个点声源w/ 55.8mm (2.2”) 中心点间距 Four Point sources w/ 55.8mm (2.2”) center-to-center spacing 建立一个线声源 Building a Line Source * 2000Hz 1.12m (44”) 没有波长传播 No wave spreading 2000Hz 四个点声源w/ 55.8mm (2.2”) 中心点间距 Five Point sources w/ 55.8mm (2.2”) center-to-center spacing 建立一个线声源 Building a Line Source * 2000Hz 1.12m (44”) 没有波长传播 No wave spreading 2000Hz 这看起来很好，但是，当频率比中心点间距还小的时候会出现什么呢？ This looks OK – BUT, what happens at frequencies smaller than the center spacing? 建立一个线声源 Building a Line Source * 6300Hz 问题 --- 大问题 Problems – Big Problems 6300Hz 线阵列 Line Array * 带有带状驱动单元的换能器 with Ribbon Transducers P L H 在同一个时间点在每个平面上再生的所有频率 All frequencies reproduced on each plane at the Same time 传感器之间的距离更加小了 Much shorter distance between transducers 传感器之间的频率耦合更高 Much higher frequency coupling between transducers 相位关系得到极大提升 Greatly improved Phase relationships * 带状的换能器有着巨大的优势 Ribbon Transducers have a enormous advantage over the competition 因为有等相位的特质 due to isophasic properties * 只有一个辐射连贯平面波的平的矩形驱动单元被密集地 放置在一起时，可以结合为一个真正的线声源系统 ONLY a flat rectangular piston Radiating a coherent planar wave Spaced tightly together Can be combined into A TRUE line source system * 合理耦合的声音辐射 Properly coupled dispersion 连续的，可控的 Consistent and Controlled 阵列的位置 Array Location 座位的位置 Seating Locations * Proper Loudspeakers 是一个线阵列 Is it a Line Array ? 还是只是“堆砌”的音箱？ Is it just “stacked up” Loudspeakers ? 还是 or for Line Arrays * 平面阵列 和仿真 Planar Array vs. Emulation * Two compression drivers With sectored waveguides High frequency planar Ribbon line source 堆叠的音箱 Stacked up Loudspeakers Three compression drivers With small aperture long Waveguides 三个压缩驱动单元 Three Compr