模型机检验标准研讨.docVIP

目 的(Aim:) 为保证机模质量，给检查作业提供依据，为客户提供合格的产品，特制定本标准。 In order to insure the quality、give the rules to the inspection action and supply our customers with super products, we establish the standards. 范 围(Range) 适用于LG公司模型机检验 All the LG dummies are valid 检验流程：（Inspection process） 注：①以上工序的检验参照相应的检验标准； All the inspection process should be comply with the relative standard. ②在检验过程中如某一检验标准不适用可省略其检验步骤。 Any standard is inapplicable, omitting the inspection process 1．模型机整机检验标准 Whole dummy inspection standard 1.1、检验标准： Inspection standard: 1.1.1 长、高、宽与样机相差小于1mm； Comparing the length、height、width with the real phone, △E1mm; 1.1.2 重量与样机相差±5g； Comparing the weight with the real phone, △E=5g 1.1.3 颜色与样机基本一致；(在客户确认样板与真机之间可接受)(在客户确认样板与真机效果之间可接受)在客户确认样板与真机效果之间可接受 callipers. (0~150mm) 1.2.2 用QC专用（0～1000g）电子秤进行测量。 Measuring with the QC electronic steelyard.(0~1000g) 在2只40W的日光灯下，光源距离被侧面30～50cm灯光下，平视距离20～30cm，上下倾斜150，用QC专用点、线标准菲林比较。 With 2pcs of 40W lamp, being 30~50cm from the lamp, 20-30cm from eyes, and leaning 150 in upper and down, Comparing with the QC standard film. 2．模型机底面壳，翻盖检验 (只适用带翻盖的模型机) Dummy body rear, folder inspection(Only folder dummy is valid ) 2.1、结构检测标准：底面壳或翻盖底面壳组装间隙须小于0.3mm，有特殊规定除外 Structure inspection standard: the gap between body rear and body front, folder upper and folder lower should be less than 0.3mm, Special ordain is excepted. 2.2、丝印检测标准:Printing inspection standard 2.2.1 丝印中间断线，断线长度只许0.1mm以下，Logo的断线必须都在0.05mm以下，尾部断线所断长度全长在2mm以下，占全长的10%以下，全长2mm以上占全长的5%以下，内容字体必须与样板保持一致，大小形状不大于或不小于样板5%； Breakage in the middle: breakage should be less than 0.1mm, breakage of logo should be less than 0.05mm;breakage in the end: printing Line≤2mm, breakage≤10%; Printing Line＞2mm, breakage≤5%; both the content and font should be keep consistent with GS, the size and shape should not be bigger or smaller 5% than GS. 2.2.2 上、下、左、右平移不许超过0.4mm倾斜角度在50以下； The shift of up, down, left, r