CO2灭火系统及烟气探测系统试验程序.docVIP

1100TEU集装箱船 JLZ010106/07 CO2灭火系统及烟气 探测系统试验程序 test procedure for co2fire extinguishing system and smoke detection system JL4267-945-02SG-15 编 制 缮 写 校 对 描 校 标 检 总重量 共4页 第1页 审 核 金陵船舶设计公司 审 定 日 期 CO2灭火系统及烟气探测系统试验程序 test procedure for co2 fire extinguishing system and smoke detection system Ⅰ. Preparation before test 1. Check all equipment, piping, fitting and warning notice of system are completed and meet requires. 检查系统所有设备,管路,附件和告示是否齐全,符合要求. 2. Check the voltage and the frequency of power source in system are correct. 检查系统电源的电压和频率是否正确. 3. Check the earth contact of each relative equipment 检查各有关设备的接地情况 4. Check the doors of release cabinet in fire control station are all close and lock up. 检查消防控制站内的释放箱的门是否都已关闭并锁住 5. Connect compressed air hose to the air-shore connection on the co2 manifold 将压缩空气软管连接到CO2主管上的空气通岸接头. 6. Manual open the both release valves of engine room and emergency engine room and put down the three way valve handle for cargo hold. 手动打开通到机舱和应急发电机室的释放阀, 及到货舱的三通阀。 7. Open the air-shore valve, lead the compressed air into the system for blow through the whole piping system. 打开压缩空气通岸阀，让压缩空气进入系统，对系统全部管路进行吹除 8. Manual close the both release valves of engine room and emergency engine room and put up three way valve. 手动关闭机舱，应急发电机室释放阀及货舱三通阀。 Ⅱ. Test process 试验程序 A. Engine room 机舱 Procedure 步骤 take measure 采取措施 test purpose 试验目的 result 结果 1 Connect compressed air to air-shore connection on manifold and put down the three way valve to disconnect with manifold 将压缩空气接到主管上的岸气接头把三通手柄向下,使与主管不接通 test for engine room 对机舱进行试验 2 Open the door of the release cabinet in fire control station 打开消防控制站释放箱的门 test for sound and light alarm 试验声光报警 3 Open the valve on air shore connection 打开空气通岸接头上的阀 check pressure gauge and pressure switch 检查压力表和压力开关 4 Manual open pilot valve used for engine room. 手动打开机舱先导阀 lead compressed air into power cylinder to open co2 main valve for engine room, record the delay time. 压缩空气进入动力缸打开机舱CO2主阀，记录延时器时间 5 Manual close pilot valv