球墨铸铁UT.docVIP

球 墨 铸 铁— 超 声 检 测 规 程 Ultrasonic Examination Procedureductile iron castings 范业军 2009年11月15日 内 容 CONTENT – 一、适用范围APPLICABLE SCOPE 二、参考标准 REFERENCES STANDARD 三、人员要求PERSONNEL QUALIFICATION 四、术语和定义TERMS DEFINITIONS 五、质量要求QUALITY REQUIREMENTS 六、检测程序EXAMINATION PROCEDURE 七、结论与报告EVALUATION AND REPORTING 一、适用范围APPLICABLE SCOPE 本规程规定了大连东北核设备无损检测有限公司对球墨铸铁的超声波检测方法及评定标准；This procedure include examination method that Ultrasonic Examination of ductile iron castings with yoke performed by Dalian Northeast Nuclear Industrial NDT Co.,Ltd 二、参考标准REFERENCES STANDARD 2.1、美国无损检测协会American Society for Non-Destructive Testing(ASNT) SNT-TC-1A (2001) 无损检测的资格和证书 Personnel Qualification and Certification in Nondestructive Testing 2.2、欧洲标准European Standard EN 12680-3 (2003) 铸造—第三部分超声检测Founding- Ultrasonic examination, Part3. Spheroidal graphite cast iron castings 三、人员要求PERSONNEL QUALIFICATION 3.1、从事超声检测人员需要持有美国无损检测学会颁发的资格证书； Ultrasonic Examination personal should hold certification by ANMT 3.2、超声检测工艺规程和工艺卡由Ⅱ级人员编制； Ultrasonic Examination card and procedure qualificated by Level II personnel. 3.3、UT的检测报告先由Ⅱ级以上人员签发。 UT examination report issued by Level II personnel. 四、术语和定义TERMS AND DEFINITIONS4.1、样品认证FPQ- First Piece Qualification 4.2、批量认证PLQ-Pilot Lot Qualification 4.3、供货商误差要求SDR- Supplier Deviation Request 五、质量要求QUALITY REQUIREMENTS quipment 将使用脉冲反射– Pulse-echo type ultrasonic instruments shall be used. 设备的最后检测日期和下次要求检测将在测试设备上表明。此期限不超过2个月。 - The date of the last calibration and the date of the next required calibration shall be displayed on the test equipment. This time period shall not exceed 2 months. 对于在钢中所传播的纵向和横向波段所设定范围从10毫米到2米将被连续检验， Range setting, from at least 10mm to 2m, shall be continuously selectable, for longitudinal and transverse waves transmitted in steel. 测量结果以至少80dB内精度为1dB的区间进行调整，最大幅度为2dB. Gain shall be adjustable in 2 dB maximum steps over a range of al leas