十矿说明书.doc

河南理工大学 采矿工程专业毕业设计说明书 姓名： 刘晓生 学号： 310702010119 学院： 能源科学与工程学院 班级： 采矿07-1班 设计题目： 平煤天安集团十矿矿井采矿专项初步设计 指导教师： 陈晓祥 职称： 副教授 二〇一一年六月平煤天安集团十矿矿井采矿专项初步设计 摘要：平煤天安集团十矿设计的井田面积为23.2Km2，年产量1.20Mt。井田内煤层赋存比较稳定，煤层平均倾角8°，平均煤厚4.23m，整体地质条件比较简单，在井田范围内无断层发育。瓦斯和二氧化碳含量相对不高，涌水量也不大。根据实际的地质资料情况进行井田开拓和准备方式的初步设计，该矿井决定采用立井上下山开采，煤层分采区上下山联合布置的开拓方式，设计采用综合机械化一次采全高回采工艺，走向长壁采煤法，用全部跨落法处理采空区。并对矿井运输、矿井提升、矿井排水和矿井通风等各个生产系统的设备选型计算，以及对矿井安全技术措施和环境保护提出要求，完成整个矿井的初步设计。矿井全部实现机械化，采用先进技术和借鉴已实现高产高效现代化矿井的经验，实现一矿一面高产高效矿井从而达到良好的经济效益和社会效益。 关键词：立井 走向长壁 一次采全高 综合机械化 Preliminary Design of Mining Special in pingmei tianan Group tenth mine Abstract：These designed allotment area for 23.2 square kilometers，Yearly Output 120 trillion. Allotment intrinsically ocurrence of coal seam compare stabilize，coal seam pitch 8acid，average coal thick 4.23m，integrally nature condition compare simplicity.Both methane and carbon dioxide content relatively do not high, and neither do inflow of water no large either. On the basis of Preliminary Design，said shaft opt in adopt three vertical shaft fluctuate mountain exploitation，coal seam grouping band region fluctuate mountain co- disposal mode of opening，design adopt comprehensive mechanization full-seam mining stopper art，Alignment longwall method，treat goaf with whole straddle alight law from actual geologic information instance proceed allotment exploit and stand-by mode. The Preliminary Design of the both combine versus mine haul, shaft exaltation, shaft drain and ventilation of mines isopuant systemic equipment lectotype count，as well as versus shaft technical safety measures and environmental protection claim，complete wholly shaft. Both shaft whole realize mechanization，adopt advanced techniques and use for reference afterwards realize high yield highly active modernization shaft experience，realize one mine not both high yield highly active shaft thereby run up to favorable economic benefit and social benefit. Keywords： Vertical shaft, Alignment long wall , fu