BOD5测定仪(中英文说明二).docVIP

BOD5测定仪 使 用 安 装 说 明 （二） 泰州市奥普特分析仪器有限公司 TaiZhou City AoPuTe Analysis Instruments Co. Ltd. ? VI, analytical methods and procedures (A) preparation, four inorganic salts Take?4?1000?ml?Clean volumetric flask set aside. 1、?Buffer solution Dissolving the following reagent with distilled water and dilute to?1000?ml (1)?、21.75?g?Potassium phosphate, dibasic?(k2HPO4) (2)?、8.5?g?Potassium dihydrogen phosphate?(KH2PO4) (3)?、33.4?g?Sodium phosphate, dibasic (?N?a?2?HPO?4?·?7?H?2?O?Humidity in the?61.0?7?%~80.51% stable) (4)?、1.7?g?Ammonium chloride (?NH?4?Cl?） 2?And magnesium sulfate solution Dissolved in distilled water?22.5?g?Magnesium sulfate (?MgSO?4?·7H?2?O?) And dilute to?1000?ml. 3?And calcium chloride solution Dissolved in distilled water is?27.5?g?Calcium chloride (?CaCl?2?) And dilute to?1000?ml. 4?And ferric chloride solution Dissolved in distilled water?0.25?g?Ferric chloride (?FeCl?3?·6H?2?O?) And dilute to?1000?ml?。 (B) sample?BOD?Measurement of the 1?, Anticipating specimens which are to be?BOD?A range of values, select the close range.營f unknown, the samples can be??COD?value, and thereby determine the range (usually?samples of?BOD?values for samples of the?COD?value of?0.8?times.?BOD?1000mg/L?, microbial samples containing sufficient oxygen, without vaccination, either directly according to the selected measuring range, found samples from the sampling scale weight.燚epending on the number of test samples (up to?8?) to determine the one samples a few flasks.營f there are only two samples, you can choosec?2~4?determination of flasks, one water sample.燛stimates of the sample ?BOD?value range, determine the amount of sampling each bottle to determine several flasks of required total amount of sampling.燩lace the water in a large beaker (i1000ml~2000ml), per?1000ml?Joined four inorganic salts the water sample? ml.燩ut the beaker into the incubator Vice either experiment on location mixing temperature ?of 2~3爃ours.燘oth must adjust the watersei?pH?value?6.?7?~7.