机械设计18_锥齿轮.pptVIP

04 Gears IV Helical, Bevel Gears Helical, Bevel and Worm Gears Straight Bevel Gears: Terminology Straight Bevel Gears: Virtual Teeth Number Straight Bevel Gears: Standard Straight Bevel Gears: Gear Ratio Force Analysis: Bevel Gearing Parallel Helical Gears: Helix Angle Helical Gears: Right and Left Helix Parallel Helical Gears: Rack Parallel Helical Gears: Pitches Parallel Helical Gears: Pressure Angles Force Analysis: Helical Gearing Helical Gears: Direction of Axial Force Helical Gearing Force Analysis: An Example Solution I: Free Body Diagram Solution II: Gearing Forces Solution II: Reactions Esc TOPIC School of Engineering Mechanical Engineering ME 462 Design of Mechanical Systems ? Tulong Zhu, All rights reserved. Straight Bevel Gears Spiral Bevel Gears Parallel Helical Gears Worm Gearset Pinion Gear Pitch cone Pitch: measured at the large end of the tooth Pitch angle: defined by the pitch cones meeting at the apex: Circular pitch, p, and pitch diameter, D, are calculated in the same manner as for spur gears. Back-cone radius, rb Cone distance, Ao Pinion Gear Pitch cone The figure shows the profile of the teeth at the back cone. The profile of the teeth at the back cone resemble that of a spur gear having a pitch radius equal to the back-cone radius, rb. where p and P are the circular pitch and diametral pitch of the imaginary spur gear. The number of teeth in this imaginary spur gear is called the virtual number of teeth Back-cone radius, rb Cone distance, Ao Pinion Gear Pitch cone Standard bevel gears: A 20o pressure angle The pinion has a longer addendum while the gear has a short addendum to avoid undercutting to increase the strength of the pinion. Full-depth teeth. Bevel gears are inherently not interchangeable, since tooth form is closely tied to the method used for producing the gears, and a different value of addendum is used for different gear ratio. See AGAMA for tooth profiles for standard straight bevel gears. Back-cone radius, rb Cone di