模具英语13.docVIP

模具专业词汇收集 一、入水：gate进入位：　gate location水口形式：gate type大水口：edge gate细水口： pin-point gate水口大小：gate size转水口：　switching runner/gate唧嘴口径：　sprue diameter二、流道: runner热流道：　hot runner, hot manifold热嘴冷流道: hot sprue/cold runner唧嘴直流: direct sprue gate圆形流道：round(full/half runner流道电脑分析：mold flow analysis流道平衡:runner balance热嘴：　hot sprue热流道板：hot manifold发热管：cartridge heater探针: thermocouples插头：　connector plug插座： connector socket密封/封料： seal三、运水：water line喉塞：line plug喉管：tube塑胶管：plastic tube快速接头：jiffy quick connector plug/socker四、模具零件：　mold components三板模：3-plate mold二板模：2-plate mold边钉/导边：leader pin/guide pin边司/导套：bushing/guide bushing中托司：shoulder guide bushing中托边L：guide pin顶针板：ejector retainer plate托板：　support plate螺丝： screw管钉：dowel pin开模槽：ply bar slot内模管位：core/cavity inter-lock顶针：　ejector pin司筒：ejector sleeve司筒针：ejector pin推板：stripper plate缩呵：movable core, return core core puller扣机（尼龙拉勾）：nylon latch lock斜顶：lifter模胚（架）： mold base上内模：cavity insert下内模：core insert行位（滑块）： slide镶件：insert压座/斜鸡：wedge耐磨板/油板：wedge wear plate压条：plate撑头: support pillar唧嘴： sprue bushing挡板：stop plate定位圈：locating ring锁扣：latch扣鸡：parting lock set推杆：push bar栓打螺丝：S.H.S.B顶板：eracuretun活动臂：lever arm分流锥：sprue spreader水口司:bush垃圾钉：stop pin隔片：buffle弹弓柱：spring rod弹弓:die spring中托司：ejector guide bush中托边：ejector guide pin镶针：pin销子：dowel pin波子弹弓：ball catch喉塞: pipe plug锁模块：lock plate斜顶：angle from pin斜顶杆：angle ejector rod尼龙拉勾：parting locks活动臂：lever arm复位键、提前回杆：early return bar气阀：valves斜导边：angle pin术语：terms承压平面平衡：parting su**ce support balance模排气：parting line venting回针碰料位：return pin and cavity interference模总高超出啤机规格：mold base shut height顶针碰运水：water line interferes with ejector pin料位出上/下模：part from cavity (core) side模胚原身出料位：cavity direct cut on A-plate, core direct cut on B-plate.不准用镶件： Do not use (core/cavity) insert用铍铜做镶件： use beryllium copper insert初步（正式）模图设计：preliminary (final) mold design反呵：reverse core弹弓压缩量：spring compressed l