Plate steel binding requirements.docVIP

Plate steel binding requirements Short slab reinforcement assembling to the next, to in the long, on the lower level is the same. Beam and plate intersect with yi, anchor into the beam slab length meet the minimum anchorage length. 6.2.1.4.7.3.1 reinforced connector location Column within the channel length are not allowed to overlap, structure of plate steel joints as far as possible to avoid loading parts, at 50% of the same cross section stagger when necessary. 6.2.1.4.7.3.2 reinforced positioning approach Along the channel direction set floor h steel horse stool, spacing is 2000 mm, the horse stool using Φ 12 reinforced. 6.2.1.5 template engineering By comparing and combining with the engineering structure features, the construction period and quality requirements, this project of the underground structure template we choose as follows. Structural parts of the template selection support (reinforced) system Base plate, pile caps, ground beam brick template The basement wall coated wood template phi 48 steel tube, wall bolt reinforcement Frame beam coated wood template bowl scaffold early complete system Basement coated wood template phi 48 steel pipe roof, wall bolt reinforcement 6.2.1.5.1 caps, basement floor template 6.2.1.5.1.1 floor under cap template Artificial cleaning the bottom of the router and after finishing cap slope, using the string cable to the center of pile caps is hanged line, steel rule measurement of pile caps, the outside building pile caps slope Angle, and to cement mortar plaster masonry slope Angle, then cushion pouring pile caps, slab concrete construction. 6.2.1.5.1.2 basement wall bottom template Cushion construction after the completion of foundation slab, the use of electronic theodolite and total station in foundation slab pad axis line of pop, according to the drawings according to have to play good axis line outside return foundation slab, the outside to play good foundation floor single line on the outside