直流系统调试大纲.docVIP

1.调试用仪器设备Instruments for debugging 表1-1调试仪器设备 Table 1-1 Instruments 电阻负载Rheostat Load 110V,80A 万用表Multimeter 2台 温度计Thermometer 1支 1000V 100MΩ兆欧表Megohmmeter 1台 3KV高压测试仪器HV Test Instrument 1台 30KVA三相调压器3-phase Voltage Regulator 1台 示波器Oscillometer 1台 注意Attention： 1.系统调测必须穿安全工作服和绝缘电工鞋； The personnel must wear safety work clothes and insulated electrician shoes during debugging; 2.系统有直流高压，禁止带电触摸铜排及其他带电裸露位置。 There is DC HV on the cabinet, so be sure not to touch the copper bar or the other naked active parts. 2. 通电前检查Check before energization 表2-1通电前检验项目表(注:如符合条件和要求请填”T”反之”F” ) Table 2-1 Check Items Before Energization （Note: Please fill in the blank of “Result” with “T” if the actual check results accord with the specifications and requirements, otherwise, fill “F”.） 分类 Sorts 序号 Ser. No. 检验项目 Inspection Items 检验标准 Inspection Standards 结果Results 交流配电 AC Distribution 1 三相交流空气开关端子间、交流接触器端子间Between 3-phase AC air breaker terminals, and between the AC contact terminals. 无短路现象 There is no short-circuit. 2 交流输入线（包括零线和地线）AC incoming wire (including the zero wire and earth wire) 接入且接线可靠 Connection and wiring are reliable. 直流配电DC Distribution 1 各回路、正负母排之间Between various circuit and between positive and negative buses. 无短路现象 There is no short-circuit. 2 电池输入空开或熔丝Battery input fuses or the air switches. 断开 disconnection 充电模块Charging Module 1 输入输出一体化端子、充电模块空开Input and output integated terminals and air switches of the charging module 交流输入无短路，插头中的插针无弯曲、变形 AC input is correct and there is no short-circuit, also the plug pins doesn’t bend or deform. 2 通信均流线、通信适配器的连接Connection of the Communication equalizaton-current wires and the communication adapters. 连接正确 The connection is correct. 3 拨码开关Code-dialing switch. 地址拨到正确位置 The address is dialed to the correct place. 配电监控Distribution Supervision and Control 1 配电监控盒的电源（+M，-M）The power supply of distribution supervision and control box (+M，-M). 极性正确 The polarity is correct. 2 配电监控盒内的拨码开关The code-dialing switch