LASER INSTRULL.pptVIP

* * COATING GEARS OPC DRUM – is an aluminum cylinder coated with light sensitive organic photoconductive material, the Drum is the heart of the all-in-one cartridge, all the other components function around it, with charging, exposing and developing, a visible image is formed on the drum surface. OPC DRUM COATED ALUMINUM SLEVE MAGNETIC AXLE MAG ROLLER – is consist of stationary magnet and a coated aluminum sleeve, the magnetic roller attracts the toner magnetically, it also charge the toner via friction with the doctor blade. An AC/DC voltage gives the toner negative charge bias and transfers the toner to the OPC. MAGNETIC ROLLER METAL AXLE CONDUCTIVE RUBBER SLEEVE PCR – is used to charge the OPC drum evenly and discharge the residual charges on the drum, it is a cylinder constructed of metal axle and conductive rubber PCR METAL STAMPING FLEXIBLE BLADE WIPER BLADE – is against the OPC Drum by wiping away the toner that was not transferred to the media, the blade is consist of a metal stamping and polyurethane blade. WIPER BLADE METAL STAMPING FLEXIBLE BLADE DOCTOR BLADE – is consist of metal stamping and a polyurethane blade, it uniformly meters the amount of toner on the magic roller, and charge the toner via friction OPC OPC THE AIR SERVE AS AN INSULATION NEGATIVEAC / DC VOLTAGE - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - PCR AN IONIZATION OCCURS WHEN THE NEGATIVE CHARGE ON THE PCR BREAKS THROUGH THE AIR INSULATION AND ATTRACTS TO THE POSITIVE CHARGE ON THE OPC’S SURFACE , THUS MAKING IT NEGATIVELY CHARGE AT -650V AS THE VOLTAGE GROW STRONGER THE NEGATIVE CHARGE ON THE PCR WILL REPELS THE NEGATIVE CHARGE ON THE OPC TOWARDS ITS CENTER, THUS LEAVING THE POSITIVE CHARGE ON TOP - - - - - - - 650V PCR - 650V ELECTRIC LATENT IMAGE WAS FORMED (-100V CHARGE) AS THE LASER HITS THE OPC SURFACE SOME OF THE NEGATIVE CHARGE DRAINS TO THE GROUND THUS LEAVING THE SURFACE TO A MUCH LOWER -100V CHARGE LASER MR NEGATIVE AC/DC VOLTS IS APPLIED TO THE MR TONER DOC