机床整流电路互锁的需要.docVIP

　机床整流电路互锁的需要 控制变压器无输入电压(输入端保险烧断或断路器跳)原因：变压器内部短路、过载线短路，电流过大无dc电流输出原因：因直流侧短路、过流、过压、过热等造成整流模块或直流电源损坏；整流电路有断线或接触不良电源连接线接触不良或断线控制变压器输入电源电压过高过低(超过±10％)或电压浪涌控制变压器损坏原因：熔断器，断路器的电流过大，没有起到保护作用：电源短路，串接：负荷过大，内部绕组短路，短路等。控制变压器副边熔断器熔断或爆断。 Control transformer no input voltage (input insurance burn out or breaker jump) reasons: transformer internal line short circuit, overload, short circuit, current no dc current output reason: because of the dc side short circuit, over-current, over-voltage, rectifier module or dc power supply damage caused overheating, etc; Rectifier circuit disconnection or poor contact power supply cables poor contact or break line control transformer input supply voltage is too high (more than + / - 10%) or too low voltage surge control transformer damage reason: fuse and circuit breaker of the current is too large, no protection, power supply circuit, concatenated: load is too large, the internal winding short circuit, short circuit, etc. Vice edge control transformer fuse fusing or broken. 外部电源开关未接通；电源进线熔断器熔芯断或机床总熔断器熔芯断；机床电源进线断；机床总电源开关坏；控制变压器输入端熔断器熔芯断(或断路器跳)；指示灯控制电路中熔断器熔芯断或断线；电源指示灯灯泡坏。 External power switch is not switched on; Power supply into line fuse core broken or machine total fuse of molten core is broken; Machine power supply into line break; Total power switch machine bad; Control transformer input fuse of molten core is broken (or circuit breaker jump); Light control circuit fuse in the molten core broken or break; Power light bulb is bad. 　i／0无输入信号，+24v电源报警 ：+24v电源保险烧坏：i／o输入短路，检查输入+24v电源是否对地短路，排除故障；更换保险。i／o无输入信号维修：更换输入／输出板在机床运行中，控制系统偶尔出现突然掉电现象原因：电源供应系统故障维修：更换系统电源，更换电源输入单元。系统工作半个月或一个月左右，必须更换电池，不然参数有可能丢失：原因：电池是为了保障系统在不通电的情况下，不会丢失nc数据维修：检查确认电池连接电缆是否有破损存储板上的电池保持回路不良，请更换存储板。电池质量不好，更换质量较好的电池。 No input signal. The I / 0, + 24 v power supply alarm: + 24 v power supply insurance burn: short circuit, I/o input check if input + 24 v power supply to ground short circuit, troubleshooting; Change the insurance. I/o no input signal maintenance: change the inpu