EMC问答题.doc

EMC考卷 1. CISPR25 Radiated Emissions 1. According to CISPR25:2008, which of the following item is NOT defined as RF boundary? B A. Artificial mains network B. Reference ground plane? C. Fiber optic signal transceiver D. RF filter 2. According to CISPR25:2008, which of the following does NOT meet the grounding and bonding requirements of the reference ground plane? B A. distance of the ground strap edges 300mm B. length to width ratio of the ground straps 7:1 C. dc resistance2.5mΩ D. the ground plane bonded to the floor of the shielded enclosure ? 3. According to CISPR25:2008, which of the following angles of harness arrangement is NOT correct? A 4牋 Anglei A. 45degrees牋 燘.90degrees 牋燙. 120degress燚. 135degre angles ? 4. When performing CISPR25 component level radiated emission testing, in order to meet the noise floor requirement for a 24dBuV/m limit at 100MHz, which of the following solution can be use? C Note: the measurement system characteristic is: 1) The scan receiver reading is 14dBuV at 100MHz 2) The antenna factor is 17dB/m at 100MHz 3) The cable loss of the system is 3dB at 100MHz A. adding 10dB attenuation B. adding 20dB attenuation C. adding a 20dB gain preamplifier (noise factor 3dB at 100MHz) D. adding a 30dB gain preamplifier (noise factor 15dB at 100MHz) 5.Per GMW3097:2006 RE at least _____ orthogonal DUT orientation shall be perform at the frequencies above ______MHz B A two ; 0.15 B three;30 C three;1000 D two;30 2. CISPR25 Conducted Emissions 1.Per CISPR25:2008, which of the following is TRUE for conducted emission test? C A Results of conducted emission current method shall be presented in dBμV B All sides of DUT shall be at least 100mm from edge of the ground plane C Broadband narrowband discrimination method shall be used D Case of DUT shall be connected to ground plane in any case. 2.Per CISPR25:2008, which of the following is Not TRUE for conducted emission test? A A load simulator shall be placed on a low rela