Remove tapered roller bearing.doc

Remove tapered roller bearing(93), (95)from gear В (output shaft) (94). 从В齿轮拆下（输出轴）圆锥滚子轴承。 DisassemЬly of converter main section. 拆卸转换器的主要部分 Unscrew hex. Socket head bolts(56),and remove seal race(55). 松开六角。套筒头螺栓，取下密封赛 Unscrew bolts(42);utilizing the threaded ex- tгaction holes, separate impeller wheel (41) fгom cover wheel(23); remove turЬine wheel assy(31). 拧松螺栓，利用螺纹前牵引孔， 从盖轮分离叶轮；拆下涡轮总成 Unscrew bolts(15);utilizing the threaded ex- tгaction holes, remove front cover(14). Re- move clutch piston(20)from the front cover. 拧松螺栓；利用螺纹前牵引孔，拆下前盖；再移动离合器活塞的前盖。 Remove oil seal rings(18)and(19)from front cover(14)and from clutch piston(20) 拆下油封环，前盖和离合器活塞。 Remove fiber plate(21)and back plate (22)fгom cover wheel(23) 拆下化纤板块和背面板盖轮 Remove snap ring(32),and remove side washer(33).Remove stator wheel(35)and free wheel cam(36).(Rollers(38)and leaf springs(37)will come off then.) 拆下卡环拆下侧垫圈。拆下定子轮和自由车轮凸轮。（辊和钢板弹簧会脱落。） After removing side washer (39), remove snapring (32),and remove washer(45).With wood blocks inserted under impeller wheel(41),remove free wheel inner race(48)by tapping its input-side end. 除去侧垫圈后，取出卡环，并除去垫圈。叶轮下插入木块，通过利用其输入侧端除去自由轮内圈。 Unscrew hex. Socket head bolts(51), and remove angular contact bearing(46)and impeller hub(40)by tapping the bearing. 松开六角。然后取出角接触球轴承与叶轮轮毂轴承。 After removing ol seal ring(52), unscrew hex. Socket head bolts(54),and separate free wheel inner race(48)from stator holder(53). 取出后醇密封环，松开六角。六角头螺栓，独立自由轮内圈从定子支架。 Disassembly of pump drive sections 拆卸泵的驱动部分 Remove snap ring(113),and remove spline hub(112).Then remove bolt(111). 拆下卡环，取出样条枢纽。然后取出螺栓。 2)Remove Рgear(109)by tapping it from inside of converter housing(137),gradually rotating the gear.将Р齿轮转换器外壳内攻，逐渐旋转的齿轮。 3)Remove snap ring(107),and remove ball bearing(108)and bearing retainer(110). 取出卡环，除去球轴承和轴承保持器。 Disassemble the charging pump drive section in a similar manner as above. 拆开充电以类似的方式与上述泵的驱动部。 18.Disassembly of PTO clutch section PTO离合器部分的拆卸 1)Remove oil seal rings(62), and remove ball bea