TCNative Reverb 中文.docVIP

TC|Native Reverb Table of Contents Display 显示 The display monitors the actual levels for input and output with Peak Hold. Move the mouse cursor into the display area and click the right mouse button. This will bring up some display options for Peak Hold. 显示监视器的实际水平的输入与输出峰值保持。移动鼠标光标在显示区域中，单击鼠标右键。这将带来一些显示选择峰值保持。 Inputmeter The inputmeter shows the level of the incoming signal after the Inputlevel Fader. 该inputmeter显示输入信号水平后，inputlevel推子。 Outputmeter Shows the outputlevel of the TC|Native Reverb. 显示outputlevel的|本地混响。 Levels 水平 Inputlevel Sets the Input level of TC|NATIVE REVERB. Because of the algorithm structure the Input level controls only the signal which feeds the reverb, not the overall level. 设置输入的热电偶|本地混响。由于算法结构的输入控制水平只有信号饲料的混响，没有整体水平。 Outputlevel Sets the Output level of TC|NATIVE REVERB. 设置输出的热电偶|本地混响。 Mixlevel 混合水平 This parameter sets the balance between the source signal and the processed signal. At 0%, you will only hear the source, while at 100% you will only hear the processed signal. 此参数设置平衡源之间的信号和信号的处理。0%，你只会听到，而在100%，你只会听到的信号处理。 Easy Edit Parameter编辑参数 Value-Dial 价值拨号 Adjusts the value of the selected parameter in the easy edit display. If you hold down CONTROL while clicking/moving, you will be able to make fine adjustments. 调整选定的参数值，在轻松编辑显示。如果你按住控制而点击移动，你将能够进行精细调整。 ROM-Switch 只读存储器开关 If you press the ROM-Switch, you can use the value-dial to choose a ROM-Preset. 如果你按rom-switch，你可以使用value-dial选择rom-preset。 Decay Time 衰变时间The reverb decay settings adjusts the lenght of the reverbation tail that is heard after an audio signal is input. It can be made longer to simulate a very large space, or shorter, depending upon your needs. 混响的衰减设置调整长度的reverbation尾巴，听说后，音频信号输入。它可以延长模拟一个非常大的空间，或短，取决于你的需要。Roomsize 房间大小 Sets the size of the room by scaling the early reflection pattern. 套房间的大小缩放的早期反射模式。 Advanced Edit Parameters 高级编辑参数 Predelay预延迟 The predelay determines the point in time when the actual reverb effect will begin in relationship to the sourc