module介绍.pptVIP

USER MODE端口 CUSTOM模块 CUSTOM模块的定义 CUSTOM模块列表信号的定义(MODE=4) CUSTOM模块列表信号的定义(MODE=7) CUSTOM模块列表信号的定义(MODE=8) Remote模块 INTEGRATOR模块 PTP Communications: Send Mode PTP Communications: Poll Mode PTP Communications: Poll/Send Mode Server模块(IPB) Server模块(BSAP) Client模块(IPB) Client模块(BSAP) PID3TERM Controller 模拟量输入模块(ANOUT) 流量控制回路 Function Module page * DESIGNER Function Block Module 软 件 培 训 FLASH CONFIGURATURE PARAMETER USER MODE端口的定义 MODE 4、7、8、51、52、53 BAUD 波特率 DATABITS 数据位 STOP 停止位 PARITY 奇偶校验位 P1 0 代表ASCII MODE 1代表RTU MODE P2 Unused Ethernet port settings are defined as follows: IP ADDR A - Primary Ethernet port address. IP ADDR B - Secondary Ethernet port address. IP MASK - Ethernet address mask. The Custom Module allows the user to configure a Bristol Babcock controller to communicate with other manufacturer’s programmable logic controllers and networks. Init 值为TRUE时，初始化模块 Repeat 定义模块发送请求信息的最小等待时间(毫秒)，通常与任务的执行速率相同。 MODE Gould Modbus： 4代表Modbus Master Mode 7代表Modbus Slave Mode 51代表Open Modbus Slave Mode 53代表Open Modbus Master Mode Enron Modbus： 8代表Modbus Slave. 52 Open Modbus Slave CustomLIST 模块需要使用信号的列表号 STATUS 模块执行后状态 COMPORT:定义端口 1PortA 2PortB 3PortC 4PortD 13Eth3 14Eth2 15Eth1 SlaveAddress 从设备地址 Timeout 等待从设备相应时间(毫秒) IPAddress specifies the Open Modbus slave RTUs IP address STATUS 模块执行后状态 DoneCount indicate completion the amount of a communication request DoneFlag Parameter is set Off when the communication request is initiated and On when the communication request is complete. SIGNAL1:FUNCTION KEY 2READ DI 4READ AI 8WRITE DO 9WRITE AO SIGNAL2:SLAVE START ADDRESS从设备信号起始地址 SIGNAL3:SIGNAL COUNT信号数量 (数量必须与列表实际信号数量一致)