- 1、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。。
- 2、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载。
- 3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
采矿学论文设计9
摘要
本设计包括三个部分:一般部分、专题部分和翻译部分。
一般部分为矿Mt/a的新井设计。井田走向平均长度为 km,倾斜方向平均长度为 km,水平面积为km2。设计主采煤层煤层,平均倾角约m。井田工业储量为,可采储量,矿井服务年限为a。井田地质条件简单。矿井正常涌水量为m3/h,最大涌水量为m3/h;矿井绝对瓦斯涌出量为m3/min,属低瓦斯矿井;煤层自燃发火倾向,煤有爆炸危险。
根据井田地质条件,提出个技术上可行开拓方案。水平标高
设计首采区采用准备方式,工作面长度m,采用一次采全高采煤法。矿井采用三八制作业,两班生产,一班检修。生产班每班,日进,循环进尺0. m,日产量。
采用输送机运煤,辅助运输采用。,最大提速,塔式摩擦轮提升机;副立井设计装备两套1.5t双层四车标准罐笼和一个带平衡锤的加宽(2.3m)罐笼,标准罐可以乘坐120人,设有轨道,可升降3t无轨胶轮车以及有轨平板车,可升降总重不超过23t的最大件设备。矿井采用中央并列式通风专题部分题目翻译部分是一篇关于的论文,英文原文题目Study on mechanism and practice of surrounding rock control of high stress coal roadway
关键词:双立井;;;准备;中央并列
ABSTRACT
This design includes three parts: general part, special part and the translation part.
The general part of Zhangcun Coal Mine2.4Mt/a Nii design. Zhangcun Coal is located in Shanxi Province, Changzhi ,area traffic is convenient. Mine toward an average length of 3.6km,average length of 8.9km tilt direction. Level area is 29.4km2. The design of the main coal seam in No. 3 coal seam, the average angle 1.2°,coal thickness of about 6.50m. Coal mine industrial reserves for the 264.2Mt,Recoverable reserves190.63Mt, recoverable reserves,mine service life for56.7a.Geological conditions. Normal mine water inflow of 196.8,maximum gushing water in mines is 266.7;absolute gas emission quantity is 27.14m3/min,belongs to low gas mine;coal seam spontaneous combustion tendency of coal dust free, with explosion risk.
According to the geological condition, put forward four feasible development plan. Through the comparison of technology and economy, choose the best scheme is: Double shaft and double level with master (under) along the mountain strike panel + along the zone development plan layout tendency. Horizontal elevation +561m.
Design of the first mining area in the panel preparation, working face length 243m by a mining full height fully mechanized top coal caving mining method and fully caving method to treat goaf. The production of two mine by means of three eight, two production,one overhaulation. The produc
文档评论(0)