复压摊铺混合料施工办法.docVIP

复压摊铺混合料施工办法 在混合料完成摊铺和刮平后应立即对路面进行检查，对不规则之处应及时用人工进行调整，随后进行充分、均匀的压实。压实分为初压、复压和终压，压路机应以均匀速度行驶。压实设备必须配有钢轮压路机、大吨位轮胎压路机及大吨位振动压路机，能按合理的压实工艺进行组合压实。并应备有经监理工程师所认可的小型振动压路机或手扶振动夯具，以用于在狭窄地点压实或修补工程。 Done in mixture paving and leveling shall be carried out on the road immediately after inspection, should be timely to the irregular differences with artificial adjustment, then adequately, uniform compaction. Compaction is divided into the early pressure, pressure and pressure, roller should be moving at uniform speed. Compaction equipment must be equipped with steel roller, large-tonnage tyre roller, and a large tonnage vibratory roller, can according to the reasonable compaction compaction process are combined. And by the supervision engineer should be accepted small vibratory roller or walking vibration rammer, for the narrow site compaction or repair project. 初压采用轻型钢筒式压路机或关闭振动的振动压路机碾压，初压后检查平整度和路拱，必要时应予以修整。复压紧接在初压后进行，复压宜采用重型的轮胎压路机，也可采用振动压路机。终压紧接在复压后进行，终压应采用双轮钢筒式压路机或关闭振动的振动压路机碾压。碾压工作应按试验路确定的试验结果办理。 Early USES light steel cylinder pressure roller on or off the vibration of the vibration road roller, the initial pressure after check the flatness and hump, when necessary, should be finish. After the pressure immediately after the initial pressure, after pressure appropriate USES heavy duty tire roller, vibratory roller may be adopted. Finishing pressure immediately after the double pressure, pressure should use double steel cylinder roller or off the vibration of the vibration road roller. RCC work shall be handled according to determine the test results of the experiment. 在碾压期间，压路机不得中途停留、转向或制动。当压路机来回交替碾压时，前后两次停留地点应相距10m以上，并应驶出压实起始线3m以外。压路机不得停留在温度高于50℃的已经压实过的混合料上。同时应采取有效措施，防止油料、润滑油、汽油等其他有机杂质在压路机操作或停放期间掉落在路面上。 During the roller compaction roller may stopover, steering or braking. When alternating back and forth roller compaction, two stay place should be above 10 m apart, and should be out of the compaction starting line outside of 3 m. Roller shall not stay at temperatures