《开放教育学习南》学习指导.docVIP

《开放教育学习指南》学习指导 打开网址：或 出现下图界面 第一次登录平台会出现“用户信息匹配”，选 “否”，然后点击“确定”按钮 在下面这个界面中，点击“确定”按钮 在下面这个界面中，输入自己的电子邮箱和手机号码后点“提交”按钮。 作业三：体验学习。 共7个体验任务，点击进入后，按照所给的提示一步步操作即可。每个体验完成后会出现这样一个大按钮，点击它，提交成功后，该体验才算完成。 作业2，测验 有单选题和判断题两项，一定确认要两项都完成之后再点“交卷” the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness. Once the lifting cylinder measurement of surface and internal c