模拟集成电路设作业_1.docVIP

《模拟集成电路设计原理》期末考试A卷 课程性质：必修 使用范围： 考试时间： 考试方式： 学号　　　　　专业　　　　班级　　　学生姓名　　　 成绩　　　　 题号 一 二 三 四 总分 得分 一．填空题（每空1分，共分）二．（每题分，共分）三．（共分） （每题分，共分）．分析计算题（共分）（下列题目中使用教材表2.1所列的器件数据，所有器件尺寸都是有效值，单位均为微米。） 4、（9分）画出下图共源极高频模型的小信号等效电路，并利用小信号模型精确推导系统的极点频率。 center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs, scrap iron and grease-free, relative position of the coupling according to the drawing requirements are. Coupling top screws, round distance apart, indicators to monitor movement of the aircraft, its value is allowed to pass the value axis moving, mounted adjustment pads, note pads installation direction guide pin coupling with process end closed. The back wheels slowly tightened, when 2mm or so, with standard white bars where two back wheel bolt hole measurement above and below, confirm two back