制作仿手绘鞋子告图的PS教程.docVIP

制作仿手绘鞋子广告图的PS教程 来源：网络作者：网络时间：2011-12-29 20:09:29点击： 482 本教程详多次用到外挂滤镜，看来现在处理图片越来越多元化接触辅助工具，其中教程也多次用到图层混合模式，制作的时候耕具不同的图片选择不同的模式。 原图 最终效果 ? 一、打开原图，背景颜色设置为黑色，用裁剪工具向左边拖动，增大左边画布如图1 ? 二、选择菜单：图像 模式 CMYK颜色,按Ctrl + J复制一层，选择菜单：图像 应用图像参数设置如图2 ? ? 三、选择菜单：图像 模式 RGB颜色,选择不要拼合图层,然后按Ctrl + J 复制一层，回到背景副本如图3所示，按Ctrl + I反相，然后把图层混合模式改为：“排除” ? ? 四、回到背景副本2,如图4所示，把图层混合模式改为：“颜色” ? ? 五、新建一层，按Ctrl +shift + alt + E 盖印图层,用白色画笔在不需要的白色背景上涂抹如图5 ? 六、这一步是降噪处理,选用：Neat Image滤镜 ? ? 七、按Ctrl + J 复制一层，选择菜单：滤镜 模糊 高斯模糊数值为6，然后再按Ctrl +Shift + Alt + F 消退数值为：76% ? ? 八、添加图层蒙版，用黑色画笔在需要清晰的地方涂抹。 ? ? 九、创建调整图层选择“色彩平衡”参数设置如图9(选择图层面版最下面中间的图标就可以选择) ? 十、新建一层选择TOPAZ滤竟镜锐化处理，锐化后用矩形选框工具把右边的鞋子部分复制出来然后变换角度再加上蒙版用黑色的画笔在不需要的地方涂抹，然后降低不透明度如图11 ? ? ? 十一、输入装饰性的文字，完成最终效果。 ?? the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to