产品生产过程控制a记录.docVIP

天水长城开关有限公司 产品生产过程控制记录 Product Process Control Record 产品名称： 型号规格： 产品编号： Product Name: Specification and Type: Product No. 定货单位 Ordering organization: 合同号 Contract No. 额定电压 Rated voltage / V 序号 No. 检验内容 Inspecting item 技术要求 Technology requirements 检验记录 Inspecting Record 序号 No. 检验内容 Inspecting item 技术要求 Technology requirements 检验记录 Inspecting Record 1 箱柜体的涂覆层Cladding and coating of cabinet 1米内平视无缺陷，涂层无损伤 There is no defect seeing paralleling within 1m, and there is no damage in coating Accord with technics 7 绝缘线卡子压接牢固 The crimp connection of insulated clip is fastness. Accord with technics 2 门缝均匀度 mm Uniformity of door gap 门缝均匀度≤1.5；1米平行缝均匀差≤2 Uniformity of door gap is less than 1.5, differently of door gap within 1m is less than 2 Accord with technics 母线支撑符合工艺 Busbar supporter meets technics Accord with technics 3 门板 Door plank 平整开启不小于90度 It should be open more than 90 degree Accord with technics 4 元件安装布置及调整 The installation, arrangement and adjustment of components 元件安装位置与图纸相符 The installing position of the components meets the requirements of drawing Accord with technics 8 母线喷漆，搪锡Painting and tinning of busbar 喷漆无流痕、无起皮、平整均匀 Painting is perfect and uniformity, there is no flow mark on the surface. Accord with technics 元件规格符合图纸The specification of the components meets the requirements of drawing Accord with technics 元件调整符合图纸要求 The adjusting of components meets the requirements of drawing Accord with technics 9 电气间隙及爬电距离（mm） Electrical clearance and creepage distance 最小电气间隙：5.5□；8□；20□ Min. electrical clearance Accord with technics 5 紧固件、镀层、铭牌、安装接地措施Fastener, coating, nameplate, earthing measure 螺丝漏出3-5扣，镀层无损伤 Screw leaks 3-5 buckles, there is no damage in coating Accord with technics 爬电距离：8□；10□；20□ Creepage distance: Accord with technics 铭牌安装正确，牢固 The installation of nameplate is correct and fastness Accord with technics 10 防护等级验证 Protection degree IP30□ IP40□ Ф2.5mm试棒不能插入 □ Ф1mm试棒不能插入 □ Ф2.5mm test bar cannot pl