虚拟串口控制显示EEPROM数据.docVIP

虚拟串口控制显示EEPROM数据.txt每个女孩都曾是无泪的天使，当遇到自己喜欢的男孩时，便会流泪一一，于是坠落凡间变为女孩，所以，男孩一定不要辜负女孩，因为女孩为你放弃整个天堂。朋友,别哭,今夜我如昙花绽放在最美的瞬间凋谢,你的泪水也无法挽回我的枯萎~~~/*------------------------------------------------------------------------------------*/ /* --- STC MCU International Limited ---------------------------------------*/ /* --- 演示STC 15 系列单片机利用定时器0实现模拟串口功能--------*/ /* --- Mobile: (86-----------------------------------------------*/ /* --- Fax: 86-755---------------------------------------------------*/ /* --- Tel: 86-755----------------------------------------------------*/ /* --- Web: www.STCMCU.com -----------------------------------------------*/ /* 如果要在程序中使用或在文章中引用该程序， -------------------- ---*/ /* 请在程序中或文章中注明使用了宏晶科技的资料及程序 -----------*/ /*-------------------------------------------------------------------------------------*/ #include STC15F104E.h #include intrins.h typedef unsigned char BYTE; typedef unsigned int WORD; /*Declare SFR associated with the IAP */ sfr IAP_DATA = 0xC2; //Flash data register sfr IAP_ADDRH = 0xC3; //Flash address HIGH sfr IAP_ADDRL = 0xC4; //Flash address LOW sfr IAP_CMD = 0xC5; //Flash command register sfr IAP_TRIG = 0xC6; //Flash command trigger //sfr IAP_CONTR = 0xC7; //Flash control register /*Define ISP/IAP/EEPROM command*/ #define CMD_IDLE 0 //Stand-By #define CMD_READ 1 //Byte-Read #define CMD_PROGRAM 2 //Byte-Program #define CMD_ERASE 3 //Sector-Erase /*Define ISP/IAP/EEPROM operation const for IAP_CONTR*/ //#define ENABLE_IAP 0x80 //if SYSCLK30MHz //#define ENABLE_IAP 0x81 //if SYSCLK24MHz //#define ENABLE_IAP 0x82 //if SYSCLK20MHz #define ENABLE_IAP 0x83 //if SYSCLK12MHz //#define ENABLE_IAP 0x84 //if SYSCLK6MHz //#define ENABLE_IAP 0x85 //if SYSCLK3MHz //#define ENABLE_IAP 0x86 //if SYSCLK2MHz //#define ENABLE_IAP 0x87 //if SYSCLK1MHz //Start address for STC15F100 series EEPROM #define IAP_ADDRESS 0x0000 //起始地址 void Delay(BYTE n); void IapIdle(); BYTE IapReadByte(WORD addr); void IapProgramByte(WORD addr, BYTE dat)